Related Experiment Video

Updated: May 29, 2026

Morphology Control for Fully Printable Organic–Inorganic Bulk-heterojunction Solar Cells Based on a Ti-alkoxide and Semiconducting Polymer
08:29

Morphology Control for Fully Printable Organic–Inorganic Bulk-heterojunction Solar Cells Based on a Ti-alkoxide and Semiconducting Polymer

Published on: January 10, 2017

Simultaneous enhancement of open-circuit voltage, short-circuit current density, and fill factor in polymer solar

Zhicai He1, Chengmei Zhong, Xun Huang

  • 1Institute of Polymer Optoelectronic Materials and Devices, State Key Laboratory of Luminescent Materials and Devices, South China University of Technology, Guangzhou 510640, PR China.

Advanced Materials (Deerfield Beach, Fla.)
|September 10, 2011
PubMed
Abstract

No abstract available in PubMed .

More Related Videos

Printing Fabrication of Bulk Heterojunction Solar Cells and In Situ Morphology Characterization07:32

Printing Fabrication of Bulk Heterojunction Solar Cells and In Situ Morphology Characterization

Published on: January 29, 2017

Integrating a Triplet-triplet Annihilation Up-conversion System to Enhance Dye-sensitized Solar Cell Response to Sub-bandgap Light11:26

Integrating a Triplet-triplet Annihilation Up-conversion System to Enhance Dye-sensitized Solar Cell Response to Sub-bandgap Light

Published on: September 12, 2014

Related Concept Videos

P-N junction01:11

P-N junction

A p-n junction is formed when p-type and n-type semiconductor materials are joined together. At the interface of the p-n junction, holes from the p-side and electrons from the n-side begin to diffuse into the opposite sides due to the concentration gradient. This diffusion of carriers leads to a region around the junction where there are no free charge carriers, known as the depletion region. The charge density within the depletion region for the n-side and p-side can be described by the...