Related Experiment Video
Updated: May 25, 2026
The Preparation and Properties of Thermo-reversibly Cross-linked Rubber Via Diels-Alder Chemistry
Published on: August 25, 2016
Effect of chemical structure and network formation on physical properties of di(cyanate ester) thermosets
Josiah T Reams1, Andrew J Guenthner, Kevin R Lamison
1National Research Council/Air Force Research Laboratory, Propulsion Directorate, Edwards AFB, CA, USA. josiah.reams.ctr@edwards.af.mil
Abstract:
Key physical properties of three dicyanate ester monomers, bisphenol A dicyanate (BADCy), bisphenol E dicyanate (LECy), and the dicyanate of a silicon-containing analogue of bisphenol A (SiMCy) were investigated as a function of cyanurate conversion at conversions ranging from approximately 70% to greater than 90% in order to assess the range of applicability of both traditional and more unusual structure-property-process relationships known for cyanate ester resins. A more complete understanding of these relationships is essential for the continued development of cyanate ester resins and their composites for a wide variety of aerospace applications. The degree of cure in each system was determined by differential scanning calorimetry (DSC). The degree of conversion achieved at a given temperature was dependent on the structure of the repeat unit, with SiMCy displaying the highest relative ease of cure. The density at room temperature was found to decrease monotonically with increasing conversion for all monomer types studied. In contrast, the water uptake decreased with increasing cure for all three materials over most or all of the conversion range studied, but leveled off or began to increase with increasing conversion at conversions of approximately 90%. The T(g) decreased after exposure to hot water in resins with greater than 85% conversion, but unexpectedly increased in samples with lower conversions. An investigation of the effect of hot water exposure on network chemistry via infrared spectroscopy indicated that carbamate formation varied with both monomer chemistry and extent of cure, but was greatest for the BADCy polycyanurates. On the other hand, the unreacted cyanate ester band tended to disappear uniformly, suggesting that reactions other than carbamate formation (such as cyclotrimerization) may also take place during exposure to hot water, possibly giving rise to the observed unusual increases in T(g) upon exposure.
Related Concept Videos
01:28Stability of Conjugated Dienes
A comparison of the enthalpies of hydrogenation of dienes reveals that conjugated dienes release less heat on hydrogenation, rendering them more stable than their nonconjugated analogs.
01:16Structure of Conjugated Dienes
Conjugated dienes are compounds characterized by the presence of alternating double and single bonds. In a conjugated system like 1,3-butadiene, the unhybridized 2p orbital on each carbon overlaps continuously, allowing the π electrons to be delocalized across the entire molecule. In contrast, this type of overlap does not occur in cumulated and isolated dienes, such as 2,3-pentadiene and 1,4-pentadiene, respectively. Instead, the π electrons remain localized between the double...
01:26Polymer Classification: Stereospecificity
01:28Structures of Carboxylic Acid Derivatives
Carboxylic acid derivatives contain an acyl group attached to a heteroatom such as chlorine, oxygen, or nitrogen. The carbonyl carbon and oxygen are both sp2-hybridized with an unhybridized p orbital.
The three sp2 orbitals of the carbonyl carbon form three σ bonds, one each with the carbonyl oxygen, the α carbon, and the heteroatom, whereas the other two sp2 orbitals of the carbonyl oxygen are occupied by the lone pairs. Further, the unhybridized p...
01:19Physical Properties of Carboxylic Acid Derivatives
Among the carboxylic acid derivatives, the boiling points of acid chlorides and esters are very similar and are the lowest in the series. Acid anhydrides have slightly higher boiling...
01:14Polymer Classification: Architecture