Effect of undercut placement on crown retention after thermocycling

The aim of this study was to examine the effect of undercuts in castings and/or tooth structure on the retention of crowns luted with glass ionomer cement. After routine full-crown preparations had been made in 48 human premolars, wax patterns were fabricated for each tooth. Retentive coves were then produced with a round bur in either the tooth structure or the wax patterns, or in both. One group of teeth and patterns did not receive any undercuts; this was the control group. Castings were made in non-precious metal. All crowns were luted with glass ionomer cement. Half of the samples were thermocycled, and the remainder were kept at 37 degrees C. Crowns were removed using tension (0.012 cm min-1) and the mean bond strengths calculated. The differences in retentive strengths were tested for statistical significance using ANOVA and Scheffe's test. The presence of coves in castings and/or tooth structure significantly increased the retentive strength of castings cemented with glass ionomer, as compared with conventional crown preparations without retentive undercuts. The effect of thermocycling on the retentive strength of castings cemented with glass ionomer was not statistically significant.