Related Experiment Video
Updated: May 24, 2026

Electrochemically and Bioelectrochemically Induced Ammonium Recovery
Published on: January 22, 2015
Effect of ammonium and nitrate on current generation using dual-cathode microbial fuel cells
Jae Kyung Jang1, Jung Eun Choi, Young Sun Ryou
1Energy and Environmental Engineering Division, National Academy of Agricultural Science, Rural Development Administration, Suwon 441-707, Korea. jkjang1052@korea.kr
Abstract:
These studies were conducted to determine the effects of various concentrations of ammonium and nitrate on current generation using dual-cathode microbial fuel cells (MFCs). Current generation was not affected by ammonium up to 51.8+/-0.0 mg/l, whereas 103.5+/-0.0 mg/l ammonium chloride reduced the current slightly. On the other hand, when 60.0+/-0.0 and 123.3+/-0.1 mg/l nitrate were supplied, the current was decreased from 10.23+/-0.07 mA to 3.20+/-0.24 and 0.20+/-0.01 mA, respectively. Nitrate did not seem to serve as a fuel for current generation in these studies. At this time, COD and nitrate removal were increased except at 123+/-0.1 mg NO(3)(-)/l. These results show that proper management of ammonium and nitrate is very important for increasing the current in a microbial fuel cell.
Related Concept Videos
Metabolism of Chemolithotrophs
Batteries and Fuel Cells
Environmental Applications of Microorganisms
2° Amines to N-Nitrosamines: Reaction with NaNO2
Microbial Nutrition
Controlled-Current Coulometry: Overview

