Analysis of the stable carbon isotope composition of formic and acetic acids

Xinqing Lee1, Like Zhang, Daikuan Huang

  • 1State Key Laboratory of Environmental Geochemistry, Institute of Geochemistry, Chinese Academy of Sciences, Guiyang, Guizhou 550002, China. lee@mail.gyig.ac.cn

Analytical Biochemistry
|February 12, 2013
PubMed

Related Concept Videos

Solution Composition During Acid/Base Titrations01:17

Solution Composition During Acid/Base Titrations

The titration of a weak acid with a strong base results in the formation of water and the conjugate base of the acid. For instance, titrating acetic acid with sodium hydroxide leads to the formation of water and sodium acetate. A solution of acetic acid and sodium acetate constitutes a buffer whose relative concentration at different stages of the titration is indicated by the α values, which represent percentages of the weak acid and its conjugate base.
The α0 and α1 values represent the...
Acidity of Carboxylic Acids01:21

Acidity of Carboxylic Acids

Carboxylic acids are the strongest organic acids. However, their acidic strength is much less than mineral acids like HCl. Carboxylic acids ionize in water and readily lose the hydroxyl proton to form a resonance-stabilized carboxylate ion.
NMR and Mass Spectroscopy of Carboxylic Acids01:30

NMR and Mass Spectroscopy of Carboxylic Acids

In ¹H NMR spectroscopy, acidic protons (–COOH) of carboxylic acids are highly deshielded and absorb far downfield, at around 9–12 ppm. The chemical shift value depends on the concentration and solvent used.
While α protons of carboxylic acids absorb at 2–2.5 ppm, β protons absorb further upfield.
Carboxylic acids are easily identified by dissolving them in deuterium oxide, which results in a rapid exchange of the acidic protons with deuterium. This leads to the disappearance of the acidic...
IR and UV–Vis Spectroscopy of Carboxylic Acids01:28

IR and UV–Vis Spectroscopy of Carboxylic Acids

In IR spectroscopy of carboxylic acids, the C=O bond shows a characteristic band between 1710 and 1760 cm⁻¹, and the O–H bond exhibits a broad band between 2500 and 3300 cm⁻¹.
However, the stretching absorptions for the C=O bond vary depending on the structure of carboxylic acids. The C=O bond of the free carboxylic acids shows a higher stretching frequency, 1760 cm−1, while H-bonded carboxylic acids (dimers) exhibit stretching absorptions at a lower frequency, 1710 cm−1. The C=O bond of the...
Titration of a Weak Acid with a Strong Base01:30

Titration of a Weak Acid with a Strong Base

In titrating a weak acid with a strong base, different calculation methods are applied at various stages. Initially, the pH of a weak acid like acetic acid is calculated using its dissociation constant (Ka) and an ICE table. Upon addition of a strong base such as sodium hydroxide, a buffer forms, and its pH is determined using the Henderson-Hasselbalch equation. As more base is added and the titration reaches the halfway point, the pH becomes equal to the pKa of the acid, indicating equal...
Nomenclature of Carboxylic Acid Derivatives: Acid Halides, Esters, and Acid Anhydrides01:16

Nomenclature of Carboxylic Acid Derivatives: Acid Halides, Esters, and Acid Anhydrides

Naming Acid Halides
The IUPAC and common names of acid halides are derived from the corresponding carboxylic acids, by changing “ic acid” to “yl halide.” For example, as shown below, the IUPAC name ethanoyl chloride is derived from ethanoic acid, and the common name, acetyl chloride, is obtained from acetic acid.