Related Experiment Video
Updated: May 11, 2026

Fabrication of Compressed Hosiery and Measurement of its Pressure Characteristic Exerted on the Lower Limbs
Published on: May 27, 2020
Load distribution to minimise pressure-related pain on foot: a model
Asanka S Rodrigo1, Ravindra S Goonetilleke, Shuping Xiong
1Department of Electrical Engineering, University of Moratuwa, Katubedda, Sri Lanka.
Abstract:
The optimal force distribution to minimise pain or discomfort at the foot-shoe interface is still not known. Most shoe-related products attempt to distribute the load uniformly without much consideration to the bony and soft tissue regions. An experiment was conducted to first determine the pressure pain threshold (PPT) and tissue deformation on the plantar surface of the foot. Circular probes of areas 0.5, 1.0 and 2.0 cm(2) at indentation speeds of 0.5, 1 and 2 mm/s showed that PPT depends on the location stimulated, area of stimulation and the indentation speed. The results also showed that tissue stiffness is quite low for small deformations ( < 4 mm), but significantly higher at large deformations (>4 mm). The stiffness at the larger deformation region was positively correlated with PPT (r = 0.63, p < 0.001). The data were further used to develop a model with PPT, deformation and stimulated area.
Practitioner Summary:
Pressure at which there is an onset of pain is higher when a larger area of soft tissue is stimulated. Bony areas may be better suited to bear load on smaller areas to minimise pressure-related pain. Thus, manipulating supporting surface stiffness and surface contours can help minimise pain.
Related Concept Videos
Peripheral Artery Disease IV: Nursing Management
Peripheral Arterial Disease II: Clinical Manifestations and Diagnostic Evaluation
Pulse Assessment Sites
Diabetic Foot Ulcer
Peripheral Artery Disease V: Postoperative Nursing Management