Related Experiment Video

Updated: May 9, 2026

Autonomous and Rechargeable Microneurostimulator Endoscopically Implantable into the Submucosa
08:17

Autonomous and Rechargeable Microneurostimulator Endoscopically Implantable into the Submucosa

Published on: September 27, 2018

Design and development of low-loss transformer for powering small implantable medical devices

K Shiba, A Morimasa, H Hirano

    IEEE Transactions on Biomedical Circuits and Systems
    |July 16, 2013
    PubMed

    More Related Videos

    Implantation and Control of Wireless, Battery-free Systems for Peripheral Nerve Interfacing07:13

    Implantation and Control of Wireless, Battery-free Systems for Peripheral Nerve Interfacing

    Published on: October 20, 2021

    Bioelectric Analyses of an Osseointegrated Intelligent Implant Design System for Amputees14:31

    Bioelectric Analyses of an Osseointegrated Intelligent Implant Design System for Amputees

    Published on: July 15, 2009

    Related Concept Videos

    Energy Losses in Transformers01:21

    Energy Losses in Transformers

    In an ideal transformer, it is assumed that there are no energy losses, and, hence, all the power at the primary winding is transferred to the secondary winding. However, in reality,  the transformers always have some energy losses, and, hence, the output power obtained at the secondary winding is less than the input power at the primary winding due to energy losses.
    There are four main reasons for energy losses in transformers.
    The first cause can be  the high resistance of the copper windings...
    Reducing Line Loss01:18

    Reducing Line Loss

    In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
    With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...
    Equivalent Circuits for Practical Transformers01:28

    Equivalent Circuits for Practical Transformers

    The practical equivalent circuits of single-phase two-winding transformers exhibit significant deviations from their idealized versions due to the inherent properties of winding resistance and finite core permeability. These properties result in real and reactive power losses, affecting the transformer's performance. Understanding these deviations is crucial for designing more efficient transformers.
    In a practical transformer, each winding exhibits resistance and leakage reactance. The winding...
    Transformers01:26

    Transformers

    A device that transforms voltages from one value to another using induction is called a transformer. A transformer consists of two separate coils, or windings, wrapped around the same soft iron core. However, they are electrically insulated from each other.
    The iron core has a substantial relative permeability. Therefore, the magnetic field lines generated due to the current in one winding are almost entirely confined within the core, such that the same magnetic flux permeates each turn of both...
    Transformers with Off-Nominal Turns Ratios01:25

    Transformers with Off-Nominal Turns Ratios

    In scenarios involving parallel transformers with disparate ratings, developing per-unit models requires accommodating off-nominal turns ratios. This situation arises when the selected base voltages are not proportional to the transformer’s voltage ratings. Consider a transformer where the rated voltages are related by the term a. If the chosen voltage bases satisfy a relationship involving term b, term c is defined as the ratio of these bases. This ratio is then substituted into the rated...
    The Ideal Transformer01:26

    The Ideal Transformer

    In single-phase two-winding transformers, two windings are coiled around a magnetic core characterized by cross-sectional area A and magnetic permeability μ. A phasor current i1 enters the left winding while i2 exits the right winding, establishing the fundamental working of the transformer through electromagnetic principles.
    Ampere's Law forms the basis of understanding the magnetic field within the transformer. It states that the integral of the magnetic field intensity's tangential component...