Related Experiment Video
Updated: Apr 28, 2026
Systematic Assessment of Mammalian Skull Specimens for Dental and Temporomandibular Joint Pathology
Published on: August 22, 2022
Correlation between dental arch width and sagittal dento-skeletal morphology in untreated adults
Atefe Saffar Shahroudi1, Tahura Etezadi1
1Assistant Professor, Dental Research Center, Tehran University of Medical Sciences, Department of Orthodontics, School of Dentistry, Lorestan University of Medical Sciences, Khoram-Abad, Iran.
Objective:
Dental arch form is one of the most important characteristics of dentition. However, this dimension usually receives less attention in diagnosis or treatment planning and orthodontic patients are traditionally classified with regard to their sagittal characteristics. The objectives of this study were to investigate if a relationship exists between the dental arch width (transverse dimension) and sagittal skeletal and dental parameters in orthodontic patients.
Materials And Methods:
Dental casts and lateral cephalograms of 108 consecutive untreated Iranian patients (47 males and 61 females) between 16 and 31 years of age were evaluated. Arch width (AW) parameters including upper and lower inter-molar width (UIMW and LIMW) and upper and lower inter-canine width (UICW and LICW) were measured by a digital caliper. Sagittal parameters included SNA and SNB angle and Wits' appraisal obtained from lateral cephalograms in addition to upper and lower arch length (UAL and LAL) obtained from dental casts. The correlation between the aforementioned parameters was evaluated applying Pearson correlation coefficients. Molar and canine relationship according to Angle's classification was also recorded and the means of all parameters were compared between three occlusal relationship classes and two gender groups by means of two-way ANOVA.
Results:
According to statistical analysis a significant positive correlation between sagittal parameters and arch width measures exists between SNA and UICW and between LICW and LAL. Upper and lower ICW were significantly correlated, the relationship between upper and lower IMW and between UAL and LAL were significant. Among sagittal measures, both UAL and LAL were correlated with the ANB angle. The means of arch width parameters in three occlusal classes were not significantly different.
Conclusion:
The only significant correlation between arch width and sagittal parameters existed between UICW and SNA angle and between LICW and LAL. No significant difference of the arch width parameter was observed between the three occlusal classes.
Related Concept Videos
01:15Teeth
In the bud stage, the tooth germ (an aggregation of cells) starts to form in the developing jawbone. During the cap stage, the tooth germ differentiates into enamel organ, dental papilla, and dental sac, which will later develop into the tooth's enamel, dentin...
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...
01:22Sutures of the Skull
Sutures are immobile joints between adjacent bones of the skull. The narrow gap between the bones is filled with dense, fibrous connective tissue that unites the bones. The long sutures located between the skull bones are not straight but instead follow irregular, tightly twisting paths. These twisting lines tightly...