Related Experiment Video
Updated: Apr 19, 2026

Mechanical Expansion of Steel Tubing as a Solution to Leaky Wellbores
Published on: November 20, 2014
The effect of using a cement gun with a narrow nozzle on cement penetration for total elbow arthroplasty: a cadaveric
Geoffrey C S Smith1, Phillip S McCann1, Danielle Simpson1
1Sydney Orthopaedic Arthritis and Sports Medicine, Chatswood, Australia; Hand Unit, Bristol Royal Infirmary, Bristol, UK.
Purpose:
To compare the cement mantle characteristics associated with use of a narrow nozzle cement gun versus the use of a 60-mL catheter tip syringe.
Methods:
Twelve cadaveric distal humeri were cemented with either a cement gun or a syringe without canal occlusion. The humeri were sectioned and photographed. The corticocancellous junction and the outer margin of the cement mantle were analyzed digitally. The corticocancellous junction defined the available area for cement penetration. The outline of the cement mantle defined the actual area of penetration. The ratio of penetration to the available area was recorded for each slice. The mean ratio for each humerus was multiplied by the number of slices in that sample containing cement to calculate a cement index.
Results:
The cement penetration ratios observed in cross-sections at the same level and the cement index were significantly greater with the use of the cement gun than with the use of the syringe. There was no difference in the number of slices that contained cement.
Conclusions:
The use of a cement gun with a narrow nozzle improved cement mantle characteristics compared with the use of a syringe when measured in a cadaveric model in the absence of canal occlusion.
Clinical Relevance:
Improving cement mantle characteristics may decrease the incidence of aseptic loosening after total elbow arythroplasty.
More Related Videos
Related Concept Videos
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...
Pore Size Distribution
Adequate...
Porosity in Cement Paste
The balance of water to cement in the mix is...
Fineness of Cement
Direct...
Hydration of Cement
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...

