Humeral Tray-Taper Failure in Modular Reverse Total Shoulder Arthroplasty

Reverse total shoulder arthroplasty (RTSA) provides reconstructive options in patients previously not candidates for total shoulder arthroplasty (TSA) or who have failed previous anatomic TSA. Revision from anatomic TSA to RTSA previously required removal of all components, a difficult and extensive procedure. Modular humeral components permit conversion from anatomic TSA to RTSA without removal of well-fixed humeral components.

Our purpose is to present a case series of patients treated for the unique and not previously reported complication of humeral tray-taper failure following modular RTSA. Challenges in diagnosis and treatment are described, including the use of dynamic fluoroscopy and manufacturer-specific instruments for component revision.

Five patients with a total of six humeral tray-taper failures were identified from 300 patients with first-generation (titanium) humeral trays over a 7-year period. Dynamic fluoroscopic evaluation aided in diagnosis in a majority of the cases. All cases have been revised to second-generation (cobalt chrome) humeral trays.

Average follow-up was 22 ± 23 months (range 3-60 months). One individual required a second revision for the same complication, but otherwise, no additional procedures were required. Symptom relief was obtained in all patients.

This case series illustrates a previously unpublished complication of humeral tray-taper junction failure following modular RTSA. Clinical and radiographic diagnosis is challenging; however, dynamic fluoroscopic evaluation permits identification of the component failure, and revision surgery results in good outcomes. We must, however, continue to evaluate what activities are recommend for patients following shoulder arthroplasty, specifically reverse total shoulder arthroplasty.