Analysis of Vertical Marginal Adaptation of Zirconia Fixed Dental Prosthesis Frameworks Fabricated by the CAD/CAM...

The purpose of this study was to evaluate the marginal adaptation of fixed dental prosthesis frameworks fabricated by computer-aided design/computer-assisted manufacture (CAD/CAM) with three different systems of data acquisition.

A total of 50 specimens were fabricated as follows: using the conventional method (Ni-Cr) (n=10); iTero/industrial milling (Group 1, n=10); Cerec Bluecam/industrial milling (Group 2, n=10); 3S/industrial milling (Group 3, n=10); and Cerec BlueCam/Sirona milling (Group 4, n=10). The specimens were numbered and randomized, and the vertical marginal discrepancy was analyzed.

Intraobserver analysis indicated no statistically significant difference (paired t test, P=.822) between periods before and after analysis. The conventional method (321 μm) showed greater discrepancy when compared with the CAD/CAM system (89 μm) (P<.001). The intraoral system showed a lower rate of marginal discrepancy when compared with the extraoral system (3S) (P<.001). The closed system presented a higher marginal discrepancy (114 μm) than the open intraoral system (iTero) at P<.001. In addition, the intraoral system when open showed statistically significant differences in mean marginal discrepancy values compared with the same system in closed condition (P>.05).

The CAD/CAM systems showed less marginal discrepancy than the conventional method for the fabrication of the frameworks.