Related Experiment Video
Updated: Sep 17, 2026
Dynamic Navigation in Endodontics: Guided Access Cavity Preparation by Means of a Miniaturized Navigation System
Published on: May 5, 2022
Convergence angles and margin widths of tooth preparations by New Zealand dental students
Janine Tiu1, Tony Lin2, Basil Al-Amleh3
1Doctoral student, Sir John Walsh Research Institute, Faculty of Dentistry, University of Otago, Dunedin, New Zealand.
Statement Of Problem:
Fundamental crown preparation principles are taught and are highly regarded in dental education. Whether tooth preparations made by dental students match these principles is unclear.
Purpose:
The purpose of this retrospective study was to report the total occlusal convergence (TOC) and margin widths of crown preparations clinically prepared by New Zealand predoctoral dental students between 2013 and mid-2015.
Material And Methods:
A total of 371 stereolithography files of tooth preparations for metal ceramic crowns prepared by predoctoral dental students were extracted from the Technical Services Laboratory database at the University of Otago. The files were put through the preparation measuring software Preppr, with outputs being TOC angles in faciolingual and mesiodistal cross sections and margin widths in facial, lingual, distal, and mesial aspects. Means, standard deviations, 95% confidence intervals, and distributions using box and whisker graphs were calculated and presented.
Results:
The majority of TOC angles fell within an acceptable range of 10 to 20 degrees; however, the angles ranged from undercuts (<0 degrees) to >60 degrees. The majority of margin widths were between 0.5 and 1 mm, while the maximum was approximately 2 mm and the minimum was 0 mm.
Conclusions:
Predoctoral dental students in New Zealand are able to produce literature-recommended TOC angles and margin widths for metal ceramic crowns; however, further attention and training are needed for excessive tooth preparations, mainly in the form of large TOC angles.
More Related Videos
07:14Guided Endodontics: Three-Dimensional Planning and Template-Aided Preparation of Endodontic Access Cavities
Published on: May 24, 2022
07:42Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
Related Concept Videos
01:15Teeth
In the bud stage, the tooth germ (an aggregation of cells) starts to form in the developing jawbone. During the cap stage, the tooth germ differentiates into enamel organ, dental papilla, and dental sac, which will later develop into the tooth's enamel, dentin...
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...