Related Experiment Video

Updated: Mar 19, 2026

Laser-Induced Fluorescence Emission L.I.F.E. as Novel Non-Invasive Tool for In-Situ Measurements of Biomarkers in Cryospheric Habitats
13:38

Laser-Induced Fluorescence Emission L.I.F.E. as Novel Non-Invasive Tool for In-Situ Measurements of Biomarkers in Cryospheric Habitats

Published on: October 26, 2019

8.5K

Massive subsurface ice formed by refreezing of ice-shelf melt ponds

Bryn Hubbard1, Adrian Luckman2, David W Ashmore1

  • 1Centre for Glaciology, Department of Geography and Earth Sciences, Aberystwyth University, Aberystwyth SY23 3DB, UK.

Nature Communications
|June 11, 2016
PubMed

More Related Videos

Ice Generation and the Heat and Mass Transfer Phenomena of Introducing Water to a Cold Bath of Brine08:16

Ice Generation and the Heat and Mass Transfer Phenomena of Introducing Water to a Cold Bath of Brine

Published on: March 13, 2017

14.6K
Identification of Plant Ice-binding Proteins Through Assessment of Ice-recrystallization Inhibition and Isolation Using Ice-affinity Purification09:43

Identification of Plant Ice-binding Proteins Through Assessment of Ice-recrystallization Inhibition and Isolation Using Ice-affinity Purification

Published on: May 5, 2017

9.2K

Related Concept Videos

Frost Action on Concrete01:27

Frost Action on Concrete

Concrete structures in cold climates, such as those along roadsides, can retain moisture. This moisture makes them susceptible to frost-related damage when temperatures fall below freezing. Adding moisture worsens the damage during temperature fluctuations, leading to repeated freezing and thawing. De-icing salts, spread over these structures to melt ice, add to the freeze-thaw cycle, and draw even more moisture into the concrete.
This freeze-thaw cycle primarily causes surface scaling, where...
520
Phase Transitions: Sublimation and Deposition02:33

Phase Transitions: Sublimation and Deposition

Some solids can transition directly into the gaseous state, bypassing the liquid state, via a process known as sublimation. At room temperature and standard pressure, a piece of dry ice (solid CO2) sublimes, appearing to gradually disappear without ever forming any liquid. Snow and ice sublimate at temperatures below the melting point of water, a slow process that may be accelerated by winds and the reduced atmospheric pressures at high altitudes. When solid iodine is warmed, the solid sublimes...
20.7K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
15.6K
Microbial Mats01:25

Microbial Mats

Microbial communities forming biofilms and mats represent complex, spatially structured ecosystems where metabolic processes are stratified according to light, oxygen, and nutrient gradients. Biofilms are initial colonization stages, only a few millimeters thick, while mature microbial mats can reach centimeter-scale thickness and display intricate vertical organization. Their structural and functional heterogeneity allows microorganisms to occupy distinct ecological niches within a few...
6
Deep Sea Microbial Ecology01:18

Deep Sea Microbial Ecology

The deep ocean and its underlying sediments represent vast, largely unexplored microbial habitats that extend far beyond the sunlit photic zone. The photic (euphotic) zone typically spans the upper ~100–200 meters of pelagic waters in the open ocean, but its depth varies geographically and seasonally, where sufficient light supports photosynthetic life. Below this lies the deep sea, spanning roughly 1000–6000 meters (bathypelagic to abyssal zones), with deeper hadal trenches...
1
States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
58.1K