Studies of surface and bulk 210Po in metals using an ultra-low background large surface alpha spectrometer
Abstract:
First measurements of natural surface and bulk 210Po specific activities for metals are reported. If covered with protective foils, the surfaces did not show indications of 210Po and the obtained upper limits are in the range of single mBqm-2. Weak bulk activities, in the range of 50 - 280mBqkg-1, were registered for Stainless Steel and Copper, while significant amounts of 210Po, ∼1.5Bqkg-1, were detected in Titanium. One special Teflon sample was investigated with respect to its bulk 210Po.
More Related Videos
12:22Speciation and Bioavailability Measurements of Environmental Plutonium Using Diffusion in Thin Films
Published on: November 9, 2015
10:31Detection and Recovery of Palladium, Gold and Cobalt Metals from the Urban Mine Using Novel Sensors/Adsorbents Designated with Nanoscale Wagon-wheel-shaped Pores
Published on: December 6, 2015
Related Concept Videos
Atomic Emission Spectroscopy: Lab
Atomic Emission Spectroscopy: Overview
Atomic Absorption Spectroscopy: Lab
Solutions containing organic solvents, such as low-molecular-mass alcohols, esters, or ketones, enhance absorbances by increasing...
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used....
Atomic Emission Spectroscopy: Instrumentation
Atomic Absorption Spectroscopy: Overview
When irradiated by EMR of a particular wavelength, these...
