Localized concentration reversal of lithium during intercalation into nanoparticles

Wei Zhang1, Hui-Chia Yu2, Lijun Wu3

  • 1Sustainable Energy Technologies Department, Brookhaven National Laboratory, Upton, NY 11973, USA.

Science Advances
|January 18, 2018
PubMed

Related Concept Videos

Concentration Cells02:41

Concentration Cells

A concentration cell is a type of a  voltaic cell constructed by connecting two almost identical half-cells, both based on the same half-reaction and using the same electrode, differing only in the concentration of one redox species. A concentration cell's potential, therefore, is determined only by the concentration difference of the particular redox species.
Consider the following voltaic cell:
25.9K
Le Chatelier's Principle: Changing Concentration02:27

Le Chatelier's Principle: Changing Concentration

A system at equilibrium is in a state of dynamic balance, with forward and reverse reactions taking place at equal rates. If an equilibrium system is subjected to a change in conditions that affects these reaction rates differently (a stress), then the rates are no longer equal and the system is not at equilibrium. The system will subsequently experience a net reaction in the direction of a greater rate (a shift) that will re-establish the equilibrium. This phenomenon is summarized by Le...
66.2K
Solution Concentration and Dilution02:59

Solution Concentration and Dilution

The relative amount of a given solution component is known as its concentration. Often, though not always, a solution contains one component with a concentration that is significantly greater than that of all other components. This component is called the solvent and may be viewed as the medium in which the other components are dispersed or dissolved. Solutions in which water is the solvent are, of course, very common on our planet. A solution in which water is the solvent is called an aqueous...
135.6K
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
664
Reversible and Irreversible Processes01:14

Reversible and Irreversible Processes

The thermodynamic processes can be classified into reversible and irreversible processes. The processes that can be restored to their initial state are called reversible processes. It is only possible if the process is in quasi-static equilibrium, i.e., it takes place in infinitesimally small steps, and the system remains at equilibrium However, these are ideal processes and do not occur naturally. An ideal system undergoing a reversible process is always in thermodynamic equilibrium within...
5.9K
Diode: Reverse bias01:14

Diode: Reverse bias

A diode is reverse-biased when the positive terminal of an external voltage source is connected to the n-type material and the negative terminal to the p-type material. This configuration opposes the natural direction of current flow through the diode, effectively increasing the width of the depletion region and the barrier potential. The reverse bias condition produces a minimal leakage current, primarily due to minority charge carriers. This leakage becomes significant when the reverse...
2.1K