Experimental evaluation of ultrasound higher-order harmonic imaging with Filtered-Delay Multiply And Sum (F-DMAS)

Giulia Matrone1, Alessandro Ramalli2, Piero Tortoli3

  • 1Dipartimento di Ingegneria Industriale e dell'Informazione, Università degli Studi di Pavia, Pavia, Italy; Centre for Health Technologies, Università degli Studi di Pavia, Pavia, Italy.

Ultrasonics
|February 6, 2018
PubMed

Related Concept Videos

Harmonic Mean01:09

Harmonic Mean

The arithmetic mean is usually skewed towards the larger values in the data set. Therefore, to avoid this inherent bias towards smaller values, the harmonic mean is used.
Take the example of the speed of a car, which is the measure of the rate of distance traveled. If the vehicle traverses the same distance back-and-forth, its average speed equals the total distance traveled divided by the total time taken. However, if the car moves with varying speeds, then the arithmetic mean is more skewed...
3.8K
Sums of Power01:22

Sums of Power

In definite integration, Riemann sums approximate the area under a curve by dividing it into subintervals and summing the areas of rectangles. When these approximations follow predictable numerical patterns, such as arithmetic or polynomial sequences, sum formulas offer a more efficient and accurate way to compute the result. In particular, the sum of consecutive integers, squares, and cubes plays an essential role in simplifying these calculations, especially when dealing with uniform...
81
Wilcoxon Rank-Sum Test01:21

Wilcoxon Rank-Sum Test

The Wilcoxon rank-sum test, also known as the Mann-Whitney U test, is a nonparametric test used to determine if there is a significant difference between the distributions of two independent samples. This test is designed specifically for two independent populations and has the following key requirements:
781
Passive Filters01:27

Passive Filters

Passive filters are utilized to shape the frequency spectrum of signals across a diverse array of applications. These filters, using only passive elements like resistors (R), inductors (L), and capacitors (C), are capable of selectively allowing or blocking certain frequency ranges without the need for external power sources.
Low-Pass Filters
Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff...
1.0K
Sum and Difference OpAmps01:22

Sum and Difference OpAmps

Operational amplifiers (op-amps) are versatile devices that extend beyond amplification. In this context, two specific op-amp configurations are explored: the summing and difference amplifiers.
A summing amplifier, or an adder, utilizes an op-amp to merge multiple input signals into a single output signal. When audio signals are introduced into its input channels, the input resistors initiate currents that traverse feedback resistors, resulting in an output voltage. Applying Kirchhoff's current...
1.4K
Active Filters01:25

Active Filters

Active filters are electronic circuits that use operational amplifiers (op-amps), resistors, and capacitors to filter out unwanted frequency components from a signal. A first-order low-pass active filter is designed to pass signals with a frequency lower than a certain cutoff frequency and attenuate frequencies higher than that cutoff frequency. The transfer function for a first-order low-pass active filter is:
1.4K