Related Experiment Video
Updated: Feb 11, 2026

Preparation of Liquid-exfoliated Transition Metal Dichalcogenide Nanosheets with Controlled Size and Thickness: A State of the Art Protocol
Published on: December 20, 2016
Surface Functionalization of Liquid-Phase Exfoliated, Two-Dimensional MoS₂ and WS₂ Nanosheets with 2-Mercaptoethanol
Dawoon Jung1, Daeyoon Kim1, Woo Joo Yang1
1Department of Energy IT, Gachon University, Seongnam 13120, Republic of Korea.
Abstract:
In this work, the UV-Vis-NIR absorption spectrum of liquid-phase exfoliated two-dimensional (2D) MoS2 nanosheets, revealed two prominent peaks at 608 nm (2.04 eV) and 668 nm (1.86 eV). These peaks were blue-shifted compared to the reported literature values and are attributed to the quantum confinement effect. Interestingly, the WS2 nanosheets exhibited the same characteristic absorption peak at ~624 nm (1.99 eV). Raman spectroscopy analysis revealed that both nanosheets displayed distinctive peaks [377.8 cm-1 and 405.6 cm-1 for MoS2, 348.3 cm-1 and 417.9 cm-1 for WS2] that originate from optical phonon modes (E12g and A1g). These peaks are shifted toward higher wavenumbers (i.e., blue-shift or phonon-stiffening) compared to bulk MoS2 and WS2, probably due to enhanced Stokes Raman scattering. Subsequently, surface functionalization of the nanosheets with 2-Mercaptoethanol was successfully performed and confirmed using optical characterization techniques, including FT-IR spectroscopy. In addition, we determined the spectral broadening after functionalization, which would be attributed to photon confinement of the nano-sized layer structure, or to inhomogeneous broadening.
Related Concept Videos
MOS Capacitor
The metal gate is typically made from highly conductive materials such as aluminum or polysilicon. Beneath the metal gate lies a thin layer of...
Phase Diagrams
Phase Transitions
Phase Transitions: Sublimation and Deposition
Dimensional Analysis
Conversion Factors and Dimensional Analysis
The unit...
Hückel's Rule Diagram of π MOs: Frost Circle
A Frost circle is constructed by drawing a polygon whose number of edges is equal to the number of carbons of the given cyclic system, with one of the vertices pointing down. Then, a circle is drawn enclosing the polygon so that...

