Related Experiment Video
Updated: Feb 8, 2026

A Real-Time Wearable Electromyography Measurement System for Small Animals
Published on: November 15, 2024
A Real-Time QRS Detection System With PR/RT Interval and ST Segment Measurements for Wearable ECG Sensors Using
Abstract:
This paper presents a real-time electrocardiogram (ECG) monitoring system for wearable devices. The system is based on the proposed parallel delta modulator architecture with local maximum point and local minimum point algorithms to detect QRS and PT waves. Therefore, using the proposed system and algorithm, real-time PR and RT intervals, and ST segment measurements can be achieved in long-term wearable ECG recording. The algorithm is tested with the MIT-BIH Arrhythmia Database for QRS complex detection and with the QT Database for the P and T wave detections. The simulation result shows that the algorithm achieves above 99%, 91%, and 98% accuracy in the QRS complex, P wave, and T wave detections, respectively. Experimental results are presented from the system prototype, in which the parallel delta modulator circuits are fabricated in IBM 0.13 $\mu \text{m}$ standard CMOS technology and the algorithms are implemented in a Xilinx Spartan-6 field programmable gate array (FPGA). The parallel delta modulators consume 720 nW at 1 kHz sampling rate with $\pm$0.6 V power supply. The proposed system has the potential to be applied in future long-term wearable ECG recording devices.
Related Concept Videos
Real Time RT-PCR
The real-time quantification of the number of amplified products is...
Interval Level of Measurement
Data measured using the interval scale are similar to ordinal level data because they have a definite arrangement. However, in the interval level of measurement, the differences between data values are meaningful even though the data does not have a starting point.
Temperature is measured using the interval scale. It is measurable data, and the difference between...
The Delta-to-Delta Circuit
Prediction Intervals
However, the point estimate is most likely not the exact value of the population parameter, but close to it. After calculating point estimates, we construct interval estimates, called confidence intervals or prediction intervals. This prediction interval comprises a range of values unlike the point estimate and is a better predictor of the observed sample value, y.
The Y-to-Delta Circuit
The initial step in analyzing a wye-to-delta circuit is to assume a positive phase sequence. These phase voltages are then utilized to calculate the line voltages that occur directly across the delta-connected load impedances. Van, Vbn, and Vcn are the phase voltages in wye, and Vab, Vbc, and Vca are the line voltages for a delta circuit. The relation between...
The Delta-to-Y Circuit

