[Optimization of Aqueous Two-Phase Extraction of Polysaccharide from Schisandra chinensis Using Response Surface
Objective:
To optimize the extraction condition of polysaccharide from Schisandra chinensis. Aqueous two-phase extraction（ ATPE） method was used, based on Box-Behnken design with Response surface methodology（ BBD-RSM）.
Methods:
solvent volume,K2HPO4 and PEG6000 were selected as the investigation factors by the single-factor experiment, and the overall desirability（ OD）of phase volume ratio, partition coefficient and extraction rates were the reponse value. BBD-RSM was used to optimize the extraction process. .
Results:
The optimal parameters were as follows,the solvent volume was 5 m L,the addition amount of K2HPO4 was 1. 0 g, the addition amount of PEG6000 was 1. 8 g and centrifugation time was 9 min, which indicated that the model had a good predictability. The predicted value was 0. 950,and the deviation between observed and predicted values was 3. 94%
Conclusion:
The ATPE technology is easy to operate and cost-effective for the extraction of polysaccharides from Schisandra chinensis.
Related Concept Videos
01:16Response Surface Methodology
The process of RSM involves several key steps:
01:26Biosynthesis of Polysaccharides
01:14Design Example: Frog Muscle Response
When the switch connecting the RL circuit is closed, a brief muscle contraction is observed. This is because, at a steady state, the inductor acts like a short...
03:03Chemical Reactions in Aqueous Solutions
02:42Aqueous Solutions and Heats of Hydration
When ionic compounds dissolve in water, the ions in the solid separate and disperse uniformly throughout the solution because water molecules surround and solvate the ions, reducing the strong electrostatic forces between them. This process...
02:01Factorial Design