Related Experiment Video
Updated: Feb 6, 2026

Author Spotlight: Advancing Anaerobic Microbiota Research Using a Novel Respirometry Protocol
Published on: April 26, 2024
Treating MTBE-contaminated water using sewage sludge-derived activated carbon
Musiliu A Liadi1, Bassam Tawabini2, Reyad Shawabkeh3
1Geosciences Department, King Fahd University of Petroleum and Minerals (KFUPM), P.O. Box 189, Dhahran, 31261, Saudi Arabia.
Abstract:
In this study, sewage sludge-derived activated carbon (SDAC) was synthesized, characterized, and tested for its potential as an adsorbent of methyl tert-butyl ether (MTBE). The SDAC was produced by activating the sludge with zinc chloride and subsequently subjected to various ranges of pyrolytic temperatures. It was then characterized using SEM/EDX, BET, and TGA. The SEM-EDX analyses showed that impurities like Fe, Al, Mg, Mn, Ca, and Na of the raw sludge were removed by the higher pyrolytic temperature and acid-washing procedures. TGA showed the thermal stability of the produced material. Results of the BET revealed a significant increase in surface area of the sludge from 1.5 m2/g to 385 m2/g after acid washing. The MTBE removal efficiency of 70% was achieved after 60 min with 2 g/L of SDAC at pH 6, and initial MTBE concentration of 1 ppm. The adsorption kinetics of SDAC fitted into pseudo-second-order reactions. This work demonstrated a beneficial use of a bio-waste material (sewage sludge) in water treatment technologies.
More Related Videos
Related Concept Videos
The Carbon Cycle
Contaminants and Errors
Another key consideration is determining the appropriate number of samples required to...
Carbon Skeletons
Water and Mineral Acquisition
States of Water
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Carbonation Shrinkage
The concrete's permeability is slightly reduced as calcium carbonate produced during the reaction fills its pores. Furthermore, its strength is slightly enhanced as the water released during the reaction...

