Effect of organic/inorganic nanoparticles on performance of polyurethane nanocomposites for potential wound dressing...

This study focuses on the evaluation and modification of polyurethane (PU) membranes containing organic and inorganic nanoparticles for potential use as a wound dressing. For the purpose of PU nanocomposite preparation, chitosan (CS) was converted into nanoparticles by the ionic-gelation method to improve its blending capability with the PU matrix. These CS nanoparticles (nano-CS) were obtained as a hydrophilic organic filler with different contents and were utilized along with inorganic titanium dioxide (TiO2) nanoparticles in the nanocomposite membrane preparation. The membranes were prepared using phase inversion technique and their microstructure was controlled by manipulating the solvent non-solvent exchange rate. Obtained results demonstrate that addition of polymer solvent to nonsolvent induced a microstructure alteration from finger-like to sponge-like, which is more suitable for fluid uptake and consequently more useful for wound dressing applications. Similar results were obtained by introduction of nanoparticles to membranes. Due to the polar nature of nanoparticles and their effects on PU structure, prepared membranes showed 71.5% improve in swelling when compared to neat PU. Moreover, the reinforcement effect of nanoparticles caused an 18.94% increase in ultimate tensile strength in comparison with bare PU film, while elongation at break was not affected considerably. In addition, prepared PU nanocomposite films showed suitable antibacterial activity of 69% against Staphylococcus aureus and did not show any toxicity to human fibroblast cells. Based on these results, simultaneous use of TiO2 and chitosan nanoparticles can improve both physical and antibacterial properties of PU as an ideal wound dressing.