Postcranioplasty seizures following decompressive craniectomy and seizure prophylaxis: a retrospective analysis at a

Journal of Neurosurgery
|September 22, 2018
PubMed
Abstract

Related Concept Videos

Seizures: Classification01:13

Seizures: Classification

Epilepsy is primarily characterized by unpredictable seizures, either provoked by an identifiable factor, such as injury or illness, or unprovoked, occurring spontaneously without apparent cause.
Seizures are typically classified into two main categories: focal and generalized seizures.
Focal Seizures
Focal seizures originate from specific regions of the brain. These seizures are further sub-classified into two types:
1.6K
Epilepsy and Seizures: Overview01:24

Epilepsy and Seizures: Overview

Epilepsy is a chronic neurological disease marked by recurrent, unpredictable seizures. These seizures are caused by abnormal electrical discharges in the brain, leading to behavior, sensation, or consciousness alterations. They can also cause transient impairment of awareness, interfering with daily activities.
Various factors can trigger epilepsy, including genetic factors, brain damage, metabolic causes, and unknown etiology. Diagnosis of epilepsy involves electroencephalography (EEG), which...
1.3K
Pedigree Analysis01:35

Pedigree Analysis

Overview
89.5K
Dimensional Analysis03:40

Dimensional Analysis

Dimensional analysis, also known as the factor label method, is a versatile approach for mathematical operations. The main principle behind this approach is: the units of quantities must be subjected to the same mathematical operations as their associated numbers. This method can be applied to computations ranging from simple unit conversions to more complex and multi-step calculations involving several different quantities and their units.
Conversion Factors and Dimensional Analysis
The unit...
64.7K
Load along a Single Axis01:29

Load along a Single Axis

In structural engineering, the analysis of beams subjected to varying loads is a critical aspect of understanding the behavior and performance of these structural elements. A common scenario involves a beam subjected to a combination of different load distributions.
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...
646
Single Pipe Systems01:24

Single Pipe Systems

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...
458