Related Experiment Video
Updated: Feb 3, 2026

Operant Procedures for Assessing Behavioral Flexibility in Rats
Published on: February 15, 2015
Comparison of Two Static Stretching Procedures on Hip Adductor Flexibility and Strength
Brandon M Fjerstad1, Roger L Hammer1, Adam M Hammer2
1Herbert H. and Grace A. Dow College of Health Professions, School of Health Sciences, Division of Exercise Science, Central Michigan University, Mt. Pleasant, MI, USA.
Abstract:
It has been shown that acute static stretching (SS) may increase flexibility, improve performance and reduce the risk of muscle strains, but may also result in decreased maximal force output. Literature review revealed little research had specifically been done on the most effective ways to stretch the hip adductor muscles. The purpose was to determine the effects that an acute bout of SS (active vs passive) has on hip adductor flexibility and maintenance of strength. Randomized cross-over study using a 3 × 2 (Condition X Time) repeated measures ANOVA statistical design. Forty healthy and physically active subjects (20 male and 20 female) that screened positive for limited flexibility in hip adductor range of motion (ROM) participated. Following a warm-up, baseline maximal voluntary isometric contraction (MVC) and peak static ROM tests were administered. On separate days subjects randomly performed either 60 seconds of passive SS, active SS, or a time-matched control protocol before post measures were recorded for MVC and ROM. There was a significant time effect (p<0.001) that revealed both types of SS and control resulted in increased ROM pre-to-post (passive = 1.0; active = 1.1; control = 0.6 degrees) with no between condition differences (p=0.171). Neither type of SS resulted in reduced strength. Both methods minimally increased hip adductor flexibility without a decrease in force output. This suggests that individuals do not need to avoid SS for the hip adductors prior to engaging in physical activity for fear of a strength decrement.
Related Concept Videos
Static Equilibrium - I
Static Equilibrium - II
Static Friction
For example, consider a scenario where a truck is connected to a car by a rope, ready to tow it along a road. When no external force is applied by the truck, the car remains stationary and is said to be in static equilibrium. In this case, the forces acting on the car, such as gravity and the...
Acid Strength and Molecular Structure
In the absence of any leveling effect, the acid strength of binary compounds of hydrogen with nonmetals (A) increases as the H-A bond strength decreases down a group in the periodic table. For group 17, the order of increasing acidity is HF < HCl < HBr < HI. Likewise, for group 16, the order of increasing acid strength is H2O < H2S < H2Se < H2Te. Across a row in the periodic table, the acid strength of binary hydrogen compounds increases with increasing...
Problem Solving in Statics
The physical situation and mathematical modeling must be considered; however, it is challenging to represent all physical situations using mathematical modeling. With the help of...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...

