Related Experiment Video
Updated: Feb 2, 2026

Performing In Vivo and Ex Vivo Electrical Impedance Myography in Rodents
Published on: June 8, 2022
In-vivo Measurements of Tissue Impeditivity by Electrical Impedance Spectroscopy
Abstract:
The electrical properties of biological tissues differ depending on their structural characteristics. In literature, a lot of study have been carried out with the intent of taking advantage of bioimpedance analysis. Unfortunately, many apparatuses used during these evaluations were not always designed for measurements on living tissues. As a consequence, data could be affected by electrode polarization. In 2016, we presented a new impedance meter, developed for measurements on living tissues. Initially, it was tested only on ex-vivo rabbit's tissues with promising results. As a continuation, this device has been tested on in-vivo samples by placing a needle-probe into 3 tissues (liver, spleen, ovary) of 2 female dogs. Furthermore, was evaluated also the bioimpedance signal of the ovary explanted, comparing it with the in-vivo data. Bioimpedance was analyzed in terms of modulus and phase along a broad spectrum of frequencies (10Hz - 10kHz).Data obtained confirm the possibility of discriminating among the 3 tested tissues, at high frequencies for modulus and at low for phase. Confirmation that values on in-vivo and exvivo tissues are comparable if detected within few minutes after the explant, is also reported. We conclude that this clinical evaluation confirmed, also in-vivo, the good performance of the device previously tested on ex-vivo tissues, and provide more information about the tissue properties and characteristics.
Related Concept Videos
Impedance Combination
Impedances and Admittance
Impedance is a measure of resistance to sinusoidal current flow in an AC circuit. Unlike their behavior in DC circuits, where inductors appear as short circuits and capacitors as open circuits, the behavior of these components in AC...
Series Impedances: Three-Phase Line
Using Kirchhoff's laws, an integro-differential equation for the network is derived. This equation accounts for unbalanced phase currents, which may induce return currents through neutral wires and the earth, seeking the least impedance path. Earth return conductors can replace the...
Bus Impedance Matrix
In the first circuit, all machine voltage sources are short-circuited, leaving only the prefault voltage source at the fault location. The positive-sequence bus impedance matrix can be determined by solving the nodal equations,...
Line Protection with Impedance Relays
Under normal conditions, low load currents keep the measured...
RLC Series Circuits: Impedance
Thus, the magnitude of the impedance is given by the following equation,

