Related Experiment Video
Updated: Jan 31, 2026

Simultaneous Monitoring of Wireless Electrophysiology and Memory Behavioral Test as a Tool to Study Hippocampal Neurogenesis
Published on: August 20, 2020
Secure Transmission for Simultaneous Wireless Information and Power Transfer in AF Untrusted Relay Networks
Hui Shi1, Weiwei Yang2, Dechuan Chen3
1Army Engineering University of PLA, No. 88 Houbiaoying, Qinhuai District, Nanjing 210007, China. lgdhpkry@aliyun.com.
Abstract:
This paper investigates secure communications of energy harvesting untrusted relay networks, where the destination assists jamming signal to prevent the untrusted relay from eavesdropping and to improve the forwarding ability of the energy constrained relay. Firstly, the source and the destination transmit the signals to the relay with maximal ratio transmission (MRT) technique or transmit antenna selection (TAS) technique. Then, the destination utilizes maximal ratio combining (MRC) technique or receive antenna selection (RAS) technique to receive the forwarded information. Therefore, four transmission and reception schemes are considered. For each scheme, the closed-form expressions of the secrecy outage probability (SOP) and the connection outage probability (COP) are derived. Besides, the effective secrecy throughput (EST) metric is analyzed to achieve a good tradeoff between security and reliability. In addition, the asymptotic performance of EST is also considered at the high signal-to-noise ratio (SNR). Finally, simulation results illustrate that: (1) the EST of the system with MRT and MRC scheme are superior to other schemes, however, in the high SNR regime, the EST of the system with MRT scheme is inferior to TAS; and (2) for the source node, there exists an optimal number of antennas to maximize the EST of the proposed schemes.
Related Concept Videos
Maximum Power Transfer
By substituting the entire circuit with...
The Maximum Power Transfer Theorem
The load connected draws the current, and the circuit delivers the power to the load. The alternating current flowing through the load is determined using the rectangular form of voltages, currents, network impedance, and load impedance. The average power delivered to the load is obtained from the product of the square of current and load resistance.
Directional Relays
Overcurrent Relays
Instantaneous overcurrent relays activate immediately when the input current exceeds a predetermined value, known as the pickup current, instantly energizing the circuit breaker trip coil. This rapid response is vital for addressing severe faults quickly.
Time-delay overcurrent relays, on the other...
Differential Relays
Line Protection with Impedance Relays
Under normal conditions, low load currents keep the measured...

