Introduction and evaluation of the ACS BCon basic course in Zaragoza, Spain

Carlos Yanez1, Antonio Güemes2, Ana Navarro1

  • 1Royo Villanova Hospital, Zaragoza, Spain.

Abstract

Related Concept Videos

AC Sources01:20

AC Sources

Direct current is a flow of electric charge in only one direction and has a steady state of constant voltage in the circuit. Rectifiers, batteries, commutator-equipped generators, and fuel cells are some examples of devices that generate direct current. Nowadays, most applications use a time-varying voltage source. Alternating current is a flow of electric charge that periodically reverses direction. An alternating current is produced by an alternating emf that is generated in a power plant. If...
4.1K
Resistor in an AC Circuit01:31

Resistor in an AC Circuit

An alternating emf or voltage source is needed to supply an alternating current (AC) to a circuit. A coil of wire rotating in a magnetic field at a constant angular speed represents such a source. It also generates a sinusoidal alternating emf and serves as an industrial alternator.
One-way current through the meter is measured using diodes. A diode is a device with better conductivity in one direction compared to the other; in its ideal state, it has zero resistance in one direction and allows...
3.2K
Power in an AC Circuit01:26

Power in an AC Circuit

In a DC circuit, the power consumed is simply the product of the DC voltage times the DC current, given in watts. However, the power consumed for AC circuits with reactive components is calculated differently. Since electrical power is the "rate" at which energy is used in a circuit, all electrical and electronic components and devices have a safe operating range for electrical power.
In a DC circuit, there is no sinusoidal waveform associated with the supply; the voltages and currents are...
2.3K
Energy Basics02:27

Energy Basics

Chemical reactions, such as those that occur when you light a match, involve changes in energy as well as matter.
47.5K
Basicity of Aliphatic Amines01:21

Basicity of Aliphatic Amines

Amines can behave as Brønsted–Lowry bases by accepting a proton from the acid to form corresponding conjugate acids. Due to a lone pair of nonbonding electrons, aliphatic amines can also act as Lewis bases by forming a covalent bond with an electrophile.
To measure the basicity of amines, two conventions are generally used. The first defines Kb as the basicity constant for the deprotonation reaction of water by the amine, as presented in Figure 1. Conventionally, lower Kb indicates higher...
6.9K
Basic Operations on Signals01:22

Basic Operations on Signals

Basic signal operations include time reversal, time scaling, time shifting, and amplitude transformations. These operations are fundamental in signal processing and analysis.
Time Reversal mirrors a continuous-time signal about the vertical axis at t=0. This is achieved by substituting t with −t. For example, if a signal x(t) is considered, the time-reversed signal is x(−t). This operation can be graphically represented, showing the mirrored signal.
1.1K