Related Experiment Video
Updated: Jan 28, 2026
Author Spotlight: Assessing Brain Activity in Robotic-Assisted Lower Limb Rehabilitation Using fNIRS
Published on: June 7, 2024
Determination of loading in the lower limb joints during step-forward lunge in fencing
Michalina Błażkiewicz1, Zbigniew Borysiuk2, Marek Gzik3
1Józef Piłsudski University of Physical Education, Faculty of rehabilitation, Warsaw, Poland.
Purpose:
Sabre is one of the three disciplines in fencing, characterised by the use of a lightweight cutting weapon to score hits on an opponent while maneuvering for position with dynamic footwork. The aim of this study is concerned with the estimation of the load applied to the lower extremities during a step-forward lunge.
Methods:
The study group comprised sixteen subjects from ASA club. Examinations of kinetic parameters of analyzed movement were carried out using Vicon system, Kistler plates and the equipment designed to measure joint torques in isometric conditions.
Results:
Maximal value of the vertical component of the ground-reaction-force generated by the lead leg is significantly higher than the one recorded in the rear leg. The maximal value of hip flexion torque of lead leg in dynamic conditions significantly exceeds the value for this joint recorded in isometric conditions. The maximal value of knee flexion of rear leg in dynamic conditions significantly exceeds the value obtained in the isometric conditions. In general, the sequence of the joint loading from the highest to the lowest is as follows: hip, knee, ankle.
Conclusions:
The comparative analysis of the torques generated by the muscles in isometric and dynamic conditions provides an adequate tool for the assessment of the characteristics of the muscle effort. Therefore, it defines the structure of movement patterns in saber, from the kinetics' point of view, in the process of improving fencing footwork.
More Related Videos
08:11Assessing Forelimb Function after Unilateral Cervical SCI using Novel Tasks: Limb Step-alternation, Postural Instability and Pasta Handling
Published on: September 16, 2013
09:52Histological Quantification to Determine Lung Fungal Burden in Experimental Aspergillosis
Published on: March 9, 2018
Related Concept Videos
01:07Development of the Limb Synovial Joints
The mesenchymal stem cells differentiate into chondrocytes that form the hyaline cartilage, and later the cartilaginous model of the bone. This model further transforms into a bone. This process is known as endochondral ossification.
During development, the limbs...
03:08Rate-Determining Steps
In a multistep reaction mechanism, one of the elementary steps progresses significantly slower than the others. This slowest step is called the rate-limiting step (or rate-determining step). A reaction cannot proceed faster than its slowest step, and hence, the rate-determining step limits the overall reaction rate.
The concept of rate-determining step can be understood from the analogy of a 4-lane freeway with a short-stretch of traffic-bottleneck caused due to...
01:25Determination of Multiple Dosing Parameters: Loading and Maintenance Doses
01:16Structural Joints: Synovial Joints
01:03Structural Joints: Fibrous Joints
Suture
All the bones of the skull, except for the mandible, are joined to each other by a fibrous joint called a suture. The fibrous connective tissue found at a suture strongly unites the adjacent skull bones and thus helps to protect the brain and form the face. In...
01:17Structural Joints: Cartilaginous Joints
There are two types of cartilaginous joints:
Synchondrosis
A synchondrosis ("joined by cartilage") is a cartilaginous joint where bones are connected by hyaline cartilage. Synchondrosis may be temporary...