Using stochastic resonance and strength training as part of a rehabilitation programme for recurrent low back pain
Jad Adrian Washif1, Jorg Teichmann2, Lian-Yee Kok3
1Sports Performance Division, National Sports Institute, Kuala Lumpur, Malaysia.
Abstract:
Low back pain (LBP) is a common disabling health problem that can cause decreased spine proprioception. Stochastic resonance (SR) can influence detection performance, besides improving patients with significant sensory deficits, but have not been thoroughly tested for LBP. This study aimed to examine the application of SR therapy (SRT) and strength training for LBP treatment. The subject was a resistance-trained male in his early thirties. His back pain was unbearable after a strength training session. Standard pain relief alleviated the pain but the LBP developed at a similar intensity after 4 weeks. SRT (4-5 sets ×90 sec, 30-sec rest interval, supine position) was prescribed along with other exercises for 3 weeks (phase 1), and followed by tailor-made strength training for 16 weeks (phase 2). The Oswestry Disability Index was 66.7% (interpreted as "crippled") prior to first SRT, and reduced to minimal levels of 15.6% and 6.7% after four and seven SRT sessions, respectively. Similarly, pain intensity was ranging from 5 to 9 (distracting-severe) of the Numeric Rating Scale (NRS-11) prior to the first session but this was reduced considerably after four sessions (NRS-11: 0-1). During phase 2, the patient performed without complaining of LBP, two repetitions of bench press exercise at a load intensity of 1.2 his body weight and attained 4 min of plank stabilisation. This LBP management strategy has a clinically meaningful effect on pain intensity, disability, and functional mobility, by receding the recurrent distracting to severe LBP.
Related Concept Videos
Resonance
Acid Strength and Molecular Structure
In the absence of any leveling effect, the acid strength of binary compounds of hydrogen with nonmetals (A) increases as the H-A bond strength decreases down a group in the periodic table. For group 17, the order of increasing acidity is HF < HCl < HBr < HI. Likewise, for group 16, the order of increasing acid strength is H2O < H2S < H2Se < H2Te. Across a row in the periodic table, the acid strength of binary hydrogen compounds increases with increasing...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Relation Between Tensile Strength and Compressive Strength of Concrete
The Equilibrium Binding Constant and Binding Strength
Strength and Heat of Hydration
The heat of hydration for each cement compound is significant; for instance, tricalcium aluminate (C3A) and...


