Percolation analysis for estimating the maximum size of particles passing through nanosphere membranes

Emily V White1, David Fullwood2, Kenneth M Golden3

  • 1Department of Chemistry, University of Utah, Salt Lake City, Utah 84112, USA.

Physical Review. E
|April 3, 2019
PubMed

Related Concept Videos

Maximum Size of Aggregate01:12

Maximum Size of Aggregate

The maximum size of aggregate is defined as the aperture of the sieve retaining 15 percent or more of the particles present in the aggregate sample. The aggregate's maximum size impacts the concrete's water requirement, workability, and strength. Larger aggregates reduce the surface area needing cement paste coverage, which can lower water needs, thereby allowing a decrease in the water-to-cement ratio when the desired workability and richness of the mix are to be maintained, which can...
537
First Pass Effect01:12

First Pass Effect

Presystemic elimination, or the first-pass effect, is the metabolism of drugs that reduces their effective concentration at the site of action. Apart from the first-pass effect, the systemic bioavailability of the drug is also reduced by other factors, including incomplete absorption or chemical degradation of drugs.
Depending on the route of administration, drugs can be metabolized in the liver, intestine, lungs, and vasculature. Orally administered drugs are first absorbed through the...
9.2K
Basic Postulates of Kinetic Molecular Theory: Particle Size, Energy, and Collision02:43

Basic Postulates of Kinetic Molecular Theory: Particle Size, Energy, and Collision

The ideal-gas equation, which is empirical, describes the behavior of gases by establishing relationships between their macroscopic properties. For example, Charles’ law states that volume and temperature are directly related. Gases, therefore, expand when heated at constant pressure. Although gas laws explain how the macroscopic properties change relative to one another, it does not explain the rationale behind it.
37.5K
Precipitate Formation and Particle Size Control01:16

Precipitate Formation and Particle Size Control

In precipitation gravimetry, the precipitating agent should react specifically or selectively with the analyte. While a specific reagent reacts with the analyte alone, a selective reagent can react with a limited number of chemical species.
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
6.3K
Maximum Deflection01:13

Maximum Deflection

When analyzing beams under unsymmetrical loads, such as a train moving on a bridge, it is crucial to accurately determine the points of maximum stress and deflection. The process involves identifying the maximum deflection of the beam, which may not always occur at its midpoint due to the uneven distribution of the load.
The maximum deflection occurs at a specific point, known as point O, where the tangent to the deflection curve is horizontal. To find point O, the slope of the tangent at any...
1.0K
Factors Affecting Dissolution: Particle Size and Effective Surface Area01:23

Factors Affecting Dissolution: Particle Size and Effective Surface Area

Dissolution kinetics, an essential aspect of oral drug delivery, is significantly influenced by the drug's particle size. According to the Noyes-Whitney dissolution model, the dissolution rate correlates directly with the drug's surface area. The larger the surface area, the higher the drug's solubility in water, leading to a faster drug dissolution rate. Reducing particle size increases the effective surface area, enhancing the dissolution process. Micronization and nanosizing are...
1.6K