[Kinematics and workspace analysis of a spherical exoskeleton parallel mechanism]

Based on the biomechanical simulation curve of OpenSim, an open source software of biomechanical model, a spherical exoskeleton parallel mechanism with two degrees of freedom for hip joint is proposed in this paper for the rehabilitation therapy of patients with impaired leg motor function or elderly people with walking dysfunction. Firstly, the parallel mechanism is modeled and the position inverse solution of the parallel mechanism is obtained using inverse kinematics analysis. The velocity analysis expression of the mechanism is derived by deriving the inverse kinematics solution. The model is imported into the mechanical system dynamics analysis software ADAMS and matrix processing analysis software MATLAB to carry out simulation experiments. The correctness of the velocity analysis is verified by comparing the velocity simulation results of the two methods. Then, three singular types of the mechanism are analyzed according to the obtained Jacobian matrix. According to the inverse solution of the mechanism, the reachable workspace of the mechanism is obtained by programming in MATLAB with given mechanism parameters and restriction conditions. Finally, the prototype platform is built. The experimental results show that the exoskeleton hip joint using this parallel mechanism can satisfy the requirement of rotation angle of human hip joint movement, but also can be good to assist patients with leg flexion-extension movement and adduction-abduction movement, and it is helpful to carry out corresponding rehabilitation training. It also has theoretical significance and application value for the research work of human hip exoskeleton parallel mechanism.