Development of a Three-dimensional Printed Emergent Burr Hole and Craniotomy Simulator

Patients with a traumatic head injury (THI) require immediate surgical intervention, as rapidly expanding intracranial hematomas can be imminently life-threatening, not permitting transfer time to neurosurgical care in a tertiary care center. In rural and remote areas, where neurosurgeons may not be readily available, surgical intervention by Community General Surgeons (CGS) may be required. Currently, the CGS in Newfoundland and Labrador (NL) do not have access to, or have experience training with, an emergent burr hole/craniotomy (EBHC) simulator. One of the barriers is the availability of inexpensive and reliable simulators to practice these skills. Therefore, a low-cost, three-dimensional (3D) printed EBHC simulator was designed and 3D-printed by MUN Med 3D (St John's, NL). The aim of this technical report is to assess the need for such simulator in rural and remote healthcare centers and report on the iterative development of the EBHC simulator. The 3D-printed EBHC simulator developed by MUN Med 3D was utilized during a general surgery workshop at the 26^th Annual Rural and Remote Medicine Conference in St. John's, NL. A total of six 3D-printed EBHC simulators were provided for the hour and a half workshop. At the end of the workshop, 16 participants were asked to provide feedback on the need for this simulator in their rural or remote environment as well as feedback on the physical attributes. The feedback received from the participants was overall positive, informative, and supported the need for the 3D-printed EBHC simulator.