Density effects on late flowering mutants of Arabidopsis thaliana under continuous light

Kiwako Yamamoto1, Kei Takahashi1, Miyuki Hara1,2

  • 1Department of Natural Sciences, International Christian University (ICU), Osawa 3-10-2, Mitaka, Tokyo 181-8585, Japan.

Related Concept Videos

Pollination and Flower Structure02:40

Pollination and Flower Structure

Flowers are the reproductive, seed-producing structures of angiosperms. Typically, flowers consist of sepals, petals, stamens, and carpels. Sepals and petals are the vegetative flower organs. Stamens and carpels are the reproductive organs.  
75.3K
Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
19.3K
Continuing Care01:25

Continuing Care

Continuing care describes the variety of health, personal, and social services provided over a prolonged period. The need for continuing care is increasing because people are living longer. Many people do not have families or others to care for them. Continuing care is mainly for patients who are disabled, functionally dependent, or suffering from a terminal disease. It is available within institutional settings or in homes. Examples include nursing centers or facilities, assisted living,...
1.9K
Continuity Equation01:28

Continuity Equation

The continuity equation asserts that the mass flow rate must remain constant for a steady flow of an incompressible fluid within a confined system. This principle applies to systems where fluid passes through varying cross-sectional areas, such as nozzles, syringes, and pipes.
The mass flow rate is expressed as:
3.3K
Continuity Equation01:20

Continuity Equation

The total amount of current flowing per unit cross-sectional area is called the current density. Hence, the current passing through a cross-sectional area can be written as the surface integral of the current density.
1.5K
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
5.1K