Related Experiment Video
Updated: Jan 20, 2026

In vitro Biofilm Formation in an 8-well Chamber Slide
Published on: January 20, 2011
Strain-to-strain variation of Rhodococcus equi growth and biofilm formation in vitro
Adina R Bujold1, Nicholas R Lani1, Macarena G Sanz2
1Department of Veterinary Clinical Sciences, Washington State University, Pullman, WA, USA.
Objective:
Rhodococcus equi is an opportunistic pathogen that causes disease worldwide in young foals and immunocompromised humans. The interactions of R. equi with the host immune system have been described; however, most studies have been conducted using a few well-characterized strains. Because biological differences between R. equi strains are not well characterized, it is unknown if experimental results will replicate when different strains are used. Therefore, our objective was to compare the growth and biofilm formation of low-passage-rate clinical isolates of R. equi to higher-passage-rate, commonly studied isolates to determine whether strain-to-strain variation exists.
Results:
Twelve strains were used: 103+, ATCC 33701, UKVDL206 103S harboring a GFP-expressing plasmid, a plasmid-cured 33701 (higher-passage-rate) and seven low-passage clinical isolates. Generation time in liquid revealed fast, moderate-fast, moderate-slow, and slow-growing isolates. The higher-passage-rate isolates were among the moderate-slow growing strains. A strain's rate of growth did not correspond to its ability to form biofilm nor to its colony size on solid media. Based on our results, care should be taken not to extrapolate in vitro work that may be conducted using different R. equi strains. Further work is needed to evaluate the effect that the observed differences may have on experimental results.
Related Concept Videos
Thermal Strain
Shearing Strain
Measurements of Strain
Strain Energy
Consider a rod that is fixed at one end and subjected to an axial force at the free end. This axial force induces stress within the rod, leading to its elongation. As the axial force increases, so does the elongation of the rod, illustrating a direct relationship between the force applied and the resulting...
Stress-Strain Diagram
Transformation of Plane Strain
Under plane strain conditions, typical for members where one dimension significantly exceeds the others, deformations and resultant strains are...

