Editor's Introduction: 2017 Rumelhart Prize Issue Honoring Lila R. Gleitman

The direction in which the induced emf drives the current around a wire loop can be found through the negative sign. However, it is usually easier to determine this direction with Lenz's law, named in honor of its discoverer, Heinrich Lenz (1804–1865). Lenz's law states that the direction of the induced emf drives the current around a wire loop always to oppose the change in magnetic flux that causes the emf.
If a bar magnet is moved toward a coil such that the magnetic flux through the coil...

An RL circuit consists of a resistor and an inductor and may have a source of emf connected to it. The inductor in the circuit helps to prevent rapid changes in current, which can be helpful if a steady current is required but the external source has a fluctuating emf. Consider an open RL circuit connected to a source of constant emf. As soon as the circuit is closed, the current begins to increase at a rate that depends only on the value of the inductance in the circuit. The greater the...

An RLC series circuit comprises an inductor, a resistor, and a charged capacitor connected in series. When the circuit is closed, the capacitor begins to discharge through the resistor and inductor by transferring energy from the electric field to the magnetic field. Here, the resistor connected to the circuit causes energy losses; therefore, on the complete discharge of the capacitor, the magnetic field energy acquired by the inductor is less than the original electric field energy of the...

Consider an RLC series circuit consisting of a resistor, an inductor, and a capacitor connected to an AC voltage source. A current, which varies sinusoidally over time, flows through the circuit, and this can be expressed by the following equation:

Rolling with slipping is a physical phenomenon that occurs when a rolling object experiences both rotational and linear motion but also experiences frictional forces that cause slipping. This phenomenon can occur in various situations, such as when a tire rolls on a wet road or a ball rolls on a rough surface.
An object's rolling motion is characterized by its rotation around its axis, while linear motion refers to the object's translational motion along a surface. Frictional forces can affect...

In the design of a supported timber beam subjected to a distributed load, both the beam's physical dimensions and the timber's characteristics, such as its grade and species, are critical. These factors determine the allowable stress values, which are crucial for calculating the necessary beam depth to ensure structural integrity and safety.
The design begins with analyzing the beam as a free body to identify moments and force balances, thereby determining support reactions. Next, the designer...