Six of one, half a dozen of the other?: Testing differences in proportions

A complete procedure for testing a claim about a population proportion is provided here.
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...

The Bonferroni test is a statistical test named after Carlo Emilio Bonferroni, an Italian mathematician best known for Bonferroni inequalities. This statistical test is a type of multiple comparison test to determine which means are different than the rest. Bonferroni test can minimize the Type 1 error by reducing the significance level alpha, which otherwise increases with sample pairs.
The means of different samples are first paired in all possible combinations.
The null hypothesis of the...

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...

The goodness–of–fit test can be used to decide whether a population fits a given distribution, but it will not suffice to decide whether two populations follow the same unknown distribution. A different test, called the test for homogeneity, can be used to conclude whether two populations have the same distribution. To calculate the test statistic for a test for homogeneity, follow the same procedure as with the test of independence. The hypotheses for the test for homogeneity can...

One-Way ANOVA can be performed on three or more samples with equal or unequal sample sizes. When one-way ANOVA is performed on two datasets with samples of equal sizes, it can be easily observed that the computed F statistic is highly sensitive to the sample mean.
Different sample means can result in different values for the variance estimate: variance between samples. This is because the variance between samples is calculated as the product of the sample size and the variance between the...

One-way ANOVA can be performed on three or more samples of unequal sizes. However, calculations get complicated when sample sizes are not always the same. So, while performing ANOVA with unequal samples size, the following equation is used: