Tin and Oxygen-Vacancy Co-doping into Hematite Photoanode for Improved Photoelectrochemical Performances

Hematite (α-Fe₂O₃) material is regarded as a promising candidate for solar-driven water splitting because of the low cost, chemical stability, and appropriate bandgap; however, the corresponding system performances are limited by the poor electrical conductivity, short diffusion length of minority carrier, and sluggish oxygen evolution reaction. Here, we introduce the in situ Sn doping into the nanoworm-like α-Fe₂O₃ film with ultrasonic spray pyrolysis method. We show that the current density at 1.23 V vs. RHE (J_ph@1.23V) under one-sun illumination can be improved from 10 to 130 μA/cm² after optimizing the Sn dopant density. Moreover, J_ph@1.23V can be further enhanced 25-folds compared to the untreated counterpart via the post-rapid thermal process (RTP), which is used to introduce the defect doping of oxygen vacancy. Photoelectrochemical impedance spectrum and Mott-Schottky analysis indicate that the performance improvement can be ascribed to the increased carrier density and the decreased resistances for the charge trapping on the surface states and the surface charge transferring into the electrolyte. X-ray photoelectron spectrum and X-ray diffraction confirm the existence of Sn and oxygen vacancy, and the potential influences of varying levels of Sn doping and oxygen vacancy are discussed. Our work points out one universal approach to efficiently improve the photoelectrochemical performances of the metal oxide semiconductors.