Related Experiment Video

Updated: Dec 23, 2025

Measuring Attention and Visual Processing Speed by Model-based Analysis of Temporal-order Judgments
13:00

Measuring Attention and Visual Processing Speed by Model-based Analysis of Temporal-order Judgments

Published on: January 23, 2017

10.2K

A revision of the virtual point detector model for calculating Nai(Tl) detector efficiency

Huynh Dinh Chuong1, Le Thi Ngoc Trang1, Vo Hoang Nguyen2

  • 1Nuclear Technique Laboratory, University of Science, Ho Chi Minh City, Viet Nam; Vietnam National University, Ho Chi Minh City, Viet Nam.

Applied Radiation and Isotopes : Including Data, Instrumentation and Methods for Use in Agriculture, Industry and Medicine
|April 21, 2020
PubMed

Keywords:
Full energy peak efficiencyNaI(Tl) detectorVirtual point detector

More Related Videos

Nanotopology of Cell Adhesion upon Variable-Angle Total Internal Reflection Fluorescence Microscopy VA-TIRFM09:14

Nanotopology of Cell Adhesion upon Variable-Angle Total Internal Reflection Fluorescence Microscopy VA-TIRFM

Published on: October 2, 2012

10.5K
Improving Reproducibility to Meet Minimal Information for Studies of Extracellular Vesicles 2018 Guidelines in Nanoparticle Tracking Analysis08:52

Improving Reproducibility to Meet Minimal Information for Studies of Extracellular Vesicles 2018 Guidelines in Nanoparticle Tracking Analysis

Published on: November 17, 2021

2.7K

Related Concept Videos

Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.0K
Transformers with Off-Nominal Turns Ratios01:25

Transformers with Off-Nominal Turns Ratios

In scenarios involving parallel transformers with disparate ratings, developing per-unit models requires accommodating off-nominal turns ratios. This situation arises when the selected base voltages are not proportional to the transformer’s voltage ratings. Consider a transformer where the rated voltages are related by the term a. If the chosen voltage bases satisfy a relationship involving term b, term c is defined as the ratio of these bases. This ratio is then substituted into the...
450
Norton's Theorem01:14

Norton's Theorem

Norton's theorem is a fundamental principle stating that a linear two-terminal circuit can be substituted with an equivalent circuit, which comprises a current source (ⅠN) in parallel with a resistor (RN). Here, ⅠN represents the short-circuit current flowing through the terminals, and RN stands for the input or equivalent resistance at the terminals when all independent sources are deactivated. This implies that the circuit illustrated in Figure (a) can be exchanged with the one depicted...
1.3K