Related Experiment Video

Updated: Dec 18, 2025

Particle Templated Emulsification enables Microfluidic-Free Droplet Assays
11:03

Particle Templated Emulsification enables Microfluidic-Free Droplet Assays

Published on: March 9, 2021

6.5K

Catastrophic thermal destabilization of two-dimensional close-packed emulsions due to synchronous coalescence

Samira Abedi1, Chau-Chyun Chen1, Siva A Vanapalli1

  • 1Department of Chemical Engineering, Texas Tech University, Lubbock, TX 79409-3121, USA. chauchyun.chen@ttu.edu siva.vanapalli@ttu.edu.

Soft Matter
|June 11, 2020
PubMed

More Related Videos

Microfluidic Preparation of Liquid Crystalline Elastomer Actuators12:04

Microfluidic Preparation of Liquid Crystalline Elastomer Actuators

Published on: May 20, 2018

9.3K
Double Emulsion Generation Using a Polydimethylsiloxane PDMS Co-axial Flow Focus Device08:58

Double Emulsion Generation Using a Polydimethylsiloxane PDMS Co-axial Flow Focus Device

Published on: December 25, 2015

16.5K

Related Concept Videos

Cycloaddition Reactions: MO Requirements for Thermal Activation01:16

Cycloaddition Reactions: MO Requirements for Thermal Activation

Thermal cycloadditions are reactions where the source of activation energy needed to initiate the reaction is provided in the form of heat. A typical example of a thermally-allowed cycloaddition is the Diels–Alder reaction, which is a [4 + 2] cycloaddition. In contrast, a [2 + 2] cycloaddition is thermally forbidden.
4.1K
Colloidal precipitates01:09

Colloidal precipitates

The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
4.2K
Colloids03:22

Colloids

Children at play often make suspensions such as mixtures of mud and water, flour and water, or a suspension of solid pigments in water known as tempera paint. These suspensions are heterogeneous mixtures composed of relatively large particles that are visible to the naked eye or can be seen with a magnifying glass. They are cloudy, and the suspended particles settle out after mixing. On the other hand, a solution is a homogeneous mixture in which no settling occurs and in which the dissolved...
20.3K
Thermal Electrocyclic Reactions: Stereochemistry01:17

Thermal Electrocyclic Reactions: Stereochemistry

The stereochemistry of electrocyclic reactions is strongly influenced by the orbital symmetry of the polyene HOMO. Under thermal conditions, the reaction proceeds via the ground-state HOMO.
Selection Rules: Thermal Activation
Conjugated systems containing an even number of π-electron pairs undergo a conrotatory ring closure. For example, thermal electrocyclization of (2E,4E)-2,4-hexadiene, a conjugated diene containing two π-electron pairs, gives trans-3,4-dimethylcyclobutene.
2.4K
Theories of Dissolution: The Danckwerts' Model and Interfacial Barrier Model01:09

Theories of Dissolution: The Danckwerts' Model and Interfacial Barrier Model

Various dissolution theories provide insight into the factors that influence the dissolution rate. Danckwerts' Model suggests that turbulence, rather than a stagnant layer, characterizes the dissolution medium at the solid-liquid interface. In this model, the agitated solvent contains macroscopic packets that move to the interface via eddy currents, facilitating the absorption and delivery of the drug to the bulk solution. The regular replenishment of solvent packets maintains the...
679
Cycloaddition Reactions: MO Requirements for Photochemical Activation01:12

Cycloaddition Reactions: MO Requirements for Photochemical Activation

Some cycloaddition reactions are activated by heat, while others are initiated by light. For example, a [2 + 2] cycloaddition between two ethylene molecules occurs only in the presence of light. It is photochemically allowed but thermally forbidden.
2.5K