Thermal Processes in Bile Ducts During Laparoscopic Cholecystectomy with Monopolar Instruments. Experimental Study...

Introduction. A significant rate of complications during laparoscopic cholecystectomy (LC) occurs due to thermal injury caused by monopolar electrosurgery (MES) equipment. Most of them manifest weeks and months after surgery with the common bile duct (CBD) and large duodenal papilla strictures, some in the early postoperative period with bile leaks. Objective. To study thermal processes occurring in the lumen and on the surface of the bile ducts during monopolar coagulation in a porcine model of LC. Methods. The temperature of the bile ducts was measured using instrumentation consisted of biliary stent with temperature sensors, which was inserted in the porcine CBD, signal amplifier, and current sense transformer. Surface temperature was measured with a scientific grade thermal camera. Cholecystectomy was performed using a standard "critical view of safety" (CVS) approach with 5 mm monopolar laparoscopic instruments. Results. Application of MES caused significant tissue heating. Lateral thermal spread and the rate of tissue heating depended on the duration of energy application and the initial tissue temperature. In 5 out of 6 experiments, the intraluminal temperature rose up to the critical threshold, and the exposure time ranged from 54 to 560 seconds. A sensor positioned at the papilla site was heated in all the experiments but still below the cell damage inducing threshold. The analysis of thermographic charts revealed the presence of the "current channeling" effect and the pedicle effect. Conclusion. There is a possibility of a direct and delayed thermal injury to the bile ducts during LC.