Effect of Confinement on Capillary Phase Transition in Granular Aggregates

Siavash Monfared1, Tingtao Zhou1, José E Andrade1

  • 1Division of Engineering and Applied Science, California Institute of Technology, Pasadena, California 91125, USA.

Physical Review Letters
|January 8, 2021
PubMed

Related Concept Videos

Transition Zone01:28

Transition Zone

The transition zone in concrete is a critical area where aggregate meets cement paste, marked by a distinct porosity and weakness compared to the surrounding material. The adhesion around the aggregates is primarily due to Van Der Waals forces. The voids within this zone influence its robustness; initially, it is less durable than the surrounding bulk mortar due to larger voids. Initially, when concrete is compacted, a higher water-cement ratio near the aggregates leads to the formation of...
230
Pore Size Distribution01:23

Pore Size Distribution

In concrete, the pore size distribution significantly influences the material's properties. Capillary pores, markedly larger than gel pores, form a vast network within partially hydrated cement paste, reducing the concrete's strength and increasing its permeability. This heightened permeability leads to a greater risk of damage from environmental factors like freeze-thaw cycles and chemical attacks, with the extent of vulnerability also being tied to the water-to-cement ratio.
Adequate...
279
Unsoundness of Aggregate due to Volume Change01:26

Unsoundness of Aggregate due to Volume Change

Unsoundness in aggregates due to volume changes is primarily caused by the physical alterations aggregates undergo, such as freezing and thawing, thermal changes, and wetting and drying. Unsound aggregates, when subjected to these changes, result in volume change upon disintegration. This, in turn, contributes to the deterioration of concrete, including scaling, pop-outs, and cracking. Particular types of aggregates, such as porous flints, cherts, and those containing clay minerals, are...
266
Colloidal precipitates01:09

Colloidal precipitates

The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
2.9K
Capillarity in Fluid01:19

Capillarity in Fluid

Capillarity describes the movement of liquid in small spaces without external forces acting on it. The capillarity is driven by surface tension and adhesive interactions between the liquid and surrounding solid surfaces. This effect is often seen in narrow tubes, porous materials, and fine particles.
Surface tension is crucial to capillarity. It results from cohesive forces between liquid molecules at the liquid-air boundary, forming a skin that resists external forces. When the capillary tube...
607