Related Experiment Video
Updated: Nov 15, 2025

Measurement of Spatial Stability in Precision Grip
Published on: June 4, 2020
Stereopsis contributes to the predictive control of grip forces during prehension
Corey A Mroczkowski1, Ewa Niechwiej-Szwedo2
1Department of Kinesiology, University of Waterloo, 200 University Ave W, Waterloo, ON, N2L 5G1, Canada.
Abstract:
Binocular viewing is associated with a superior prehensile performance, which is particularly evident in the latter part of the reach as the hand approaches and makes contact with the target object. However, the visuomotor mechanisms through which binocular vision serves prehension are not fully understood. This study assessed the role of stereopsis in the predictive control of grasping by measuring grip force. Twenty participants performed a precision reach-to-grasp task in four viewing conditions: binocular, monocular, and with reduced stereoacuity (200 arc sec, > 400 arc sec). Monocular, compared to binocular viewing, was associated with a fourfold increase in grasp errors, a 56% increase in grasp duration, 22% decrease in grip force at 50 ms following grasp initiation, and the time of peak force occurred 40% later after grasp initiation (all p < 0.05). Grasp performance was also disrupted when viewing with reduced stereoacuity. Notably, grip force at the time of object lift-off was comparable between all viewing conditions. These results demonstrate that binocular stereopsis contributes to the efficient programming of grip forces. Specifically, stereopsis may provide important sensory information that enables the central nervous system to engage in predictive control of grasping.
Related Concept Videos
Control Systems
At the heart...
Feedback control systems
Linear feedback systems are theoretical models that simplify analysis and design. These systems operate under the principle that their output is directly proportional to their input within certain ranges. For instance, an amplifier in a control system behaves linearly as long as the input signal remains within a specific range. However, most physical systems exhibit inherent nonlinearity...
Open and closed-loop control systems
An open-loop control system operates without feedback from the output. It consists of two primary elements: the controller and the controlled process. The controller receives an input signal...
Static and Kinetic Frictional Force
However, if two systems are in contact and are stationary relative to one...
Hierarchy of Motor Control

