Solution Processing of Topochemically Converted Layered WO₃ for Multifunctional Applications

Solution processing of nanomaterials is a promising technique for use in various applications owing to its simplicity and scalability. However, the studies on liquid-phase exfoliation (LPE) of tungsten oxide (WO₃ ) are limited, unlike others, by a lack of commercial availability of bulk WO₃ with layered structures. Herein, a one-step topochemical synthesis approach to obtain bulk layered WO₃ from commercially available layered tungsten disulfide (WS₂ ) by optimizing various parameters like reaction time and temperature is reported. Detailed microscopic and spectroscopic techniques confirmed the conversion process. Further, LPE was carried out on topochemically converted bulk layered WO₃ in 22 different solvents; among the solvents studied, the propan-2-ol/water (1 : 1) co-solvent system appeared to be the best. This indicates that the possible values of surface tension and Hansen solubility parameters for bulk WO₃ could be close to that of the co-solvent system. The obtained WO₃ dispersions in a low-boiling-point solvent enable thin films of various thickness to be fabricated by using spray coating. The obtained thin films were used as active materials in supercapacitors without any conductive additives/binders and exhibited an areal capacitance of 31.7 mF cm^-2 at 5 mV s^-1 . Photo-electrochemical measurements revealed that these thin films can also be used as photoanodes for photo-electrochemical water oxidation.