Data Link with a High-Power Pulsed Quantum Cascade Laser Operating at the Wavelength of 4.5 µm

This article is a short study of the application of high-power quantum cascade lasers and photodetectors in medium-infrared optical wireless communications (OWC). The link range is mainly determined by the transmitted beam parameters and the performance of the light sensor. The light power and the photodetector noise directly determine the signal-to-noise power ratio. This ratio could be maximized in the case of minimizing the radiation losses caused by atmospheric attenuation. It can be obtained by applying both radiation sources and sensors operated in the medium infrared range decreasing the effects of absorption, scattering or scintillation, beam spreading, and beam wandering. The development of a new class of laser sources based on quantum cascade structures becomes a prospective alternative. Regarding the literature, there are descriptions of some preliminary research applying these lasers in data transmission. To provide a high data transfer rate, continuous wave (cw) lasers are commonly used. However, they are characterized by low power (a few tens of mWatts) limiting their link range. Also, only a few high-power pulsed lasers (a few hundreds of mWatts) were tested. Due to their limited pulse duty cycle, the obtained modulation bandwidth was lower than 1 MHz. The main goal of this study is to experimentally determine the capabilities of the currently developed state-of-the-art high-power pulsed quantum cascade (QC) lasers and photodetectors in OWC systems. Finally, the data link range using optical pulses of a QC laser of ~2 W, operated at the wavelength of ~4.5 µm, is discussed.