3D Printed Chest Wall: A Tool for Advanced Microsurgical Training Simulating Depth and Limited View

The deep inferior epigastric perforator (DIEP) flap has become the free flap of choice for autologous breast reconstruction. However, anastomoses of DIEP pedicles to internal mammary vessels in the chest wall are difficult due to restricted access and the depth of the vessels. Successful performance of such demanding procedures necessitates advanced requirements for microsurgical training models. The current chicken thigh model has been used to acquire microsurgical skills, allowing early learning curve trainees to practice repeatedly in inconsequential environments. Despite the increasing use of this model for training purposes, the resemblance to a clinical environment is tenuous. Such models should include anastomosis practice within the depth where the recipient vessels are located. To address this, we developed a three-dimensional (3D) printed chest wall as an addition to the current chicken thigh model, which reliably mimics the complexity of the anastomosis performed during DIEP breast reconstruction. This form of rapid prototyping facilitates a newfound ability for early learning curve trainees to exercise end-to-end anastomoses on vessels located with variable depths. Our enhancement of the current chicken thigh model is simple, cost-effective and offers a significantly more realistic resemblance to a clinical situation.