Intraoperative Assessment of Gap Balancing in Total Knee Arthroplasty Using Navigation with Joint Stability Graphs

The purpose of this study was to assess continuous gaps in the replaced knee throughout the full range of motion (ROM) after total knee arthroplasty (TKA) using a joint stability graph, and to analyze the gap laxity in the mid-flexion range. Ninety-three TKAs were performed using imageless navigation with a joint stability graph. While positioning guides for each respective cut, the surgeon can safely preview the resection's impact for the resulting joint gaps and control the soft tissue balance at the knee flexion of 0° (extension) and 90° (flexion). The gaps between the femoral component and insert were evaluated throughout the full ROM using the joint stability graph. The mechanical axis (MA) and change of joint line height were radiographically evaluated. Posthoc power analyses using a significant α value of 0.05 were performed on the proportion of the mid-flexion instability as a primary outcome to determine whether the sample had sufficient power. The power was determined to be sufficient (100%). The flexion-extension gap differences in each medial and lateral compartment and the mediolateral gap differences in flexion and extension were all ≤3 mm. None of the knees had mid-flexion instability, which is defined by a peak mid-flexion gap that is 3 mm greater than the smaller value of flexion or extension gap. The average MA was well corrected from varus 11.4° to varus 1.0° postoperatively. The proportion of postoperative well-aligned knees (MA ≤ 3°) was 87.1%. The joint line height was well preserved (14.7 vs. 14.8 mm, p = 0.751). The joint stability graph in TKA using the navigation can effectively evaluate the continuous gap throughout the ROM, including the mid-flexion range. Mid-flexion instability was uncommon in primary TKAs with appropriate alignment and proper preservation of the joint line. The Level of evidence for the study is IV.