Related Experiment Video
Updated: Sep 21, 2025
Continuous-Wave Propagation Channel-Sounding Measurement System - Testing, Verification, and Measurements
Published on: June 25, 2021
Analysis of LTE-M Adjacent Channel Interference in Rail Transit
Hao Fu1, Xiaoyong Wang2, Xuefan Zhang1
1Key Laboratory of Specialty Fiber Optics and Optical Access Networks, Shanghai University, Shanghai 200444, China.
Abstract:
Long Term Evolution-Metro (LTE-M), as a special communication system for train control, has strict requirements on adjacent channel interference (ACI). According to the 3rd Generation Partnership Project (3GPP) protocol of the European Telecommunications Standards Institute (ETSI) standards, this paper presents the required isolation degree for LTE-M systems to resist ACI. Aiming at the scenario of leaky cable transmission and antenna transmission adopted by the underground LTE-M system of the subway, the isolation degree required for LTE-M system deployment is deduced by combining the channel description with the principle of ACI. For the coexistence of a LTE-M system and an adjacent cellular system in a subway ground scenario, the Monte-Carlo (MC) method is used to simulate several conceivable scenarios of the LTE-M system and the adjacent frequency cellular system. In addition, the throughput loss of the LTE-M system is estimated by considering signal to interference plus noise ratio (SINR). Simulation results demonstrate that adjacent frequency user equipment (UE) has negligible small interference with the LTE-M underground system when using the leaky cable radiation pattern, whereas for the LTE-M ground system, the main interference comes from the adjacent frequency UE to the LTE-M base station (BS). Finally, interference avoidance solutions are presented, which can be utilized as a reference in the design and deployment of LTE-M systems in the rail transit environment.
Related Concept Videos
01:23Transmission Line Design Considerations
01:12Mesh Analysis for AC Circuits
The process of harmonizing these impedances begins with a clear understanding of the input and output signals. Once these signals are known, the...
01:26Transmission-Line Differential Equations
Line Section Model
A circuit representing a line section of length Δx helps in understanding the transmission line parameters. The voltage V(x) and current i(x) are measured...
01:10Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
01:27Traveling Waves: Lossless Lines
01:24Bus Impedance Matrix
In the first circuit, all machine voltage sources are short-circuited, leaving only the prefault voltage source at the fault location. The positive-sequence bus impedance matrix can be determined by solving the nodal equations,...