Related Experiment Video
Updated: Aug 29, 2025

Procedure to Evaluate the Efficiency of Flocculants for the Removal of Dispersed Particles from Plant Extracts
Published on: April 9, 2016
Using Polymer-Surfactant Charge Ratio to Control Synergistic Flocculation of Anionic Particulate Dispersions
Christopher Hill1, Wasiu Abdullahi1, Martin Crossman2
1School of Science, Faculty of Engineering and Science, University of Greenwich, Chatham Maritime, Kent ME4 4TB, UK.
Abstract:
This study investigates the flocculation induced destabilization of particulate dispersions by oppositely charged polymer−surfactant complexes, with a particular focus on controlling interactions by modulating the charge ratio Z, (where Z = [+polymer]/[−surfactant]) via [−surfactant] at fixed Cpolymer. Cationic hydroxyethyl cellulose (cat-HEC) polymer-sodium dodecylsulfate (SDS) complexes were prepared with either excess polymer (Z > 1) or surfactant (Z < 1) charges. Anionic particulate dispersions (Ludox and polystyrene-butadiene Latex) were then exposed to the complexes, and solvent relaxation NMR was used to characterize the particle surfaces before and after exposure. In both particulate dispersions, flocculation induced destabilization was enhanced after exposure to cat-HEC-SDS complexes with Z > 1, leaving any excess particle surfaces uncoated after gentle centrifugation. However, complexes with Z < 1 showed no adsorption and destabilization in the Ludox dispersions and only slight destabilization in the Latex dispersions due to possible hydrophobic interactions. Substituting SDS for non-ionic surfactant (C12E6) showed no additional destabilization of the dispersions, but post-centrifugation relaxation rates indicated preferential adsorption of C12E6 onto the particle surfaces. Since the dominant forces are electrostatic, this study highlights the possibility of controlling the interactions between oppositely charged polymer−surfactant complexes and particle surfaces by modulating Z through [−surfactant].
More Related Videos
07:01Preparation of Hollow Polystyrene Particles and Microcapsules by Radical Polymerization of Janus Droplets Consisting of Hydrocarbon and Fluorocarbon Oils
Published on: January 25, 2018
10:12Flash NanoPrecipitation for the Encapsulation of Hydrophobic and Hydrophilic Compounds in Polymeric Nanoparticles
Published on: January 7, 2019
Related Concept Videos
Colloidal precipitates
Coagulation
Colloids
Solubility
A solution is a homogeneous mixture composed of a solvent, the major component, and a solute, the minor component. The physical state of a solution—solid, liquid, or gas—is typically the same as that of the solvent. Solute concentrations are often described with qualitative terms such as dilute (of relatively low concentration) and concentrated (of relatively high concentration).
In a solution, the solute particles (molecules,...
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Factors Affecting Solubility