[Effect of particle size and emulsifier on pharmacokinetic values of a parenterally administered fat emulsion]

To evaluate pharmacokinetic data during parenteral application of a fat emulsion a controlled study in healthy volunteers was performed. Another aim of the study was to investigate whether these kinetics could be changed by modification of the emulsion. For this purpose, 10 male medical students--free of any metabolic disorders--received modified batches of one fat emulsion (Lipovenös), differing with respect to particle size or emulsifier. The emulsions were applied using a pump-controlled continuous infusion technique. The dosage was calculated according to body weight: 0.1 g/kg B.W./h. There was a 7-10 day interval between one application and the following study period, again using the same volunteers. Thus every volunteer served as his own control. Routine laboratory parameters as well as parameters relating to fat metabolism were measured. While routine laboratory parameters were not statistically different between the groups, pharmacokinetic data showed differences according to the batches used. Highest triglyceride and free fatty acid levels i.s. were present after application of the emulsion with low medium particle size, while lowest levels were found after increasing the particle size to 380 nm. In addition, it could be documented that an increase in medium particle size resulted in higher elimination rate, transfer and pool size. The modified emulsifier led to an additional increase of these effects, thus inducing beneficial metabolic profiles. The results of the present investigation might perhaps enable us to adjust the profile of future fat emulsions, with the aim of optimizing or restoring metabolic hemostasis.