Related Experiment Video
Updated: Aug 25, 2025
Structural Design and Manufacturing of a Cruiser Class Solar Vehicle
Published on: January 30, 2019
Mattress Coil Spring Fatigue and Weight-Bearing Support: Comparison of Weight-Bearing and Non-Weight-Bearing Springs
Bert H Jacobson1, Masoud Moghaddam2, Carlos A Estrada3
1School of Kinesiology and Applied Health, Oklahoma State University, Stillwater, Oklahoma.
Objective:
The purpose of this study was to compare the firmness of used mattress coil springs from the areas bearing greatest body weight versus areas subjected to little compression.
Methods:
Weight-bearing springs (WBS) extracted from the center of the mattresses (N = 32), and non-weight-bearing springs (NWBS) extracted from the head/foot were of the same mattresses. To determine spring weakness, a 1296-g ingot was placed on the coil, and the compression distance was measured (cm). In addition, a gauge was used to measure the amount of pressure required to compress the coil springs a distance of 2 cm. Comparison between WBS and NWBS data were statistically treated using independent t tests and a 1-way analysis of variance.
Results:
There were no significant group differences in weight or height in unloaded coils. However, there were significant (P < .05) differences in coil spring compression distance under load (WBS = 2.78 ± 0.34 cm; NWBS = 1.52 ± 0.39 cm) and force gauge compression (WBS = 1090.51 ± 88.42 g; NWBS = 1213.12 ± 71.38 g) between groups.
Conclusion:
This study found that WBSs were weaker when compressed than the NWBS from used mattresses, and such characteristics may not be visually apparent in a mattress when not in use. Thus, coil springs in bedding systems may eventually fail to provide the initial structural support after use. Such sagging may compromise sleep posture with accompanying poor sleep quality and quantity.
Related Concept Videos
01:23Euler's Formula to Columns: Problem Solving
The system comprises two vertical rigid bars, AB and BC,...
01:23Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
01:17Frequency of Spring-Mass System
Consider a block on a spring on a frictionless surface. There...
01:15Posttensioned Masonry Walls
Post-tensioned masonry walls use high-strength steel rods or flexible tendons to enhance the strength and efficiency of masonry structures. These elements are securely anchored to the foundation and extend vertically either within the cores of the masonry units or between the masonry wythes. The construction process involves building the wall with these tensioning elements in place and allowing the mortar to fully cure.
Following the curing process, the tensioning begins. Steel rods are...
01:22Bearing Stress
Due to the intricacy of these microforces, an average value, known as bearing stress, is often used by...
01:24Comparison Between Electrical And Gravitational Forces
Since both are inverse square law forces, the distance gets canceled when the ratio of the two forces is considered. Instead, the ratio of the electrical and gravitational forces depends on...