Hybrid Polymer Composites Based on Polystyrene (PS) Used in the Melted and Extruded Manufacturing Technology

As part of the work, innovative hybrid polymer composites dedicated to rapid prototyping, especially for 3D printing with the melted and extruded manufacturing (MEM) technique, were developed. For this purpose, the influence of modified fillers, such as alumina-modified silica, bentonite modified with quaternary ammonium salt, and lignin/silicon dioxide hybrid filler, on the functional properties of polystyrene-based composites was investigated. The introduced additives were selected to improve the processing properties of polystyrene (PS), in particular its thermal stability, while maintaining good mechanical properties. In the first part of the work, using the proprietary technological line, filaments from unfilled PS and its composites were obtained, which contain modified fillers in the amount of 1.5% to 3.0% by weight. Samples for testing functional properties were obtained by 3D printing in MEM technology and injection technique. The rheological properties-mass melt flow rate (MFR), viscosity, and mechanical properties-are presented in the further part of the work. The size and the respective dispersion in the polystyrene polymer matrix of the fillers used were determined by scanning electron microscopy with energy dispersion spectroscopy (SEM/EDS). The correct dispersion of additives in PS was also confirmed by wide-angle X-ray analysis (WAXS). A significant improvement in the thermal stability of the obtained composites after the introduction of fillers into the polymer matrix was confirmed on the basis of thermogravimetric analysis (TGA). The remaining tests of physicochemical properties, differential scanning calorimetry (DSC), and infrared spectroscopy with Fourier transform (FT-IR) allowed us to state no significant changes in relation to polystyrene. The obtained test results allowed us to conclude that the amount and type of fillers used in the PS polymer matrix significantly affect the performance properties of the tested hybrid composites. The composites obtained as part of the work can be successfully used in rapid prototyping technologies, especially for the production of details originally designed from PS, which are required to have higher thermal stability than is guaranteed only by the polymer matrix.